Loading ...
Loading ...
Loading ...
9. SETTING THE VACUUM CLEANER
FIG. 8
9.7 SWITCHING ON - FIG. 8
Now connect the vacuum cleaner to the power supply
and switch the vacuum cleaner ‘ON’ by pushing the
switch “|”.
Now use the vacuum cleaner as normal.
WARNING: EXPLOSION AND FIRE HAZARD.
Never vacuum asbestos, inflammable fluids, such as
petrol, oil, solvents, etc. Do not operate near inflammable
fluids or gas. Never vacuum fluids or material hotter than
60°C, such as burning cigarettes, ashes, glowing coals,
etc.
If cable becomes damaged, replace immediately.
Always keep the cloth filter clean for maximum
performance.
FIG. 9
9.8 CHANGING SETUP FROM DRY TO
WET VACUUMING - FIG. 9
Empty the tank and dispose of any dirt/dust which
may have been picked up previously.
Remove the cloth filter if fitted.
Now fit the foam filter . This slides over the
float cage as shown.
NEVER VACUUM DRY DUST AND DIRT WITH THIS
FILTER FITTED AS IT WILL PROVIDE LITTLE OR NO
PROTECTION RESULTING IN MOTOR DAMAGE.
Refit the motor housing by securing with the two
retaining clips.
FIG. 10
9.9 WATER LEVEL - FIG. 10
Note: The crevice nozzle should be used when the
water level is too high to use attachment.
To ensure the air flow is adequate, we recommend that
the end of the nozzle is not totally immersed.
When the fluids have reached the highest permittable
level in the tank, the float regulator will cover the
motor air inlet causing the motor to work harder, it will
become noisier, at this point turn off and empty the tank.
13
Loading ...
Loading ...
Loading ...