Loading ...
Loading ...
Loading ...
Attach Detergent Siphon Hose te Pemp
The pressure washer is equipped with two detergent
siphoning hoses. One is attached to the cleaning tank and
one is loose for siphoning pressure washer safe detergents
from a bottle or container.
Attach one of the detergent siphon hoses (A) to the barbed
hose fitting (B) on the pump.
iMPORTANT:Only one detergent siphoning hose can be used
at a time. When cleaning tank is not used, makesure
detergent shut-off valve on cleaning tank is in the "Off"
position.
Add Engine Oil
1. Place pressure washer on a flat, ievei surface.
2. Cleanarea around oii fiii and remove yeiiow oii fiii
cap/dipstick.
NOTE:See 0i/Recommendations in Maintenancesection.
Verify provided oil bottle is the correct viscosity for current
ambient temperature.
3. Using oiI funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening.
NOTICE
improper treatment of pressurewasher can damage it and
shorten its life.
DONOTattemptto crankor sta!t the enginebeforeit hasbeen
properlyservicedwiththe recommendedoil. This mayresultin
anenginefailure.
4. Replaceoil fill cap/dipstick and fully tighten.
Add Fee?
Fuel must meet these requirements:
Clean,fresh, unleaded gasoline.
. A minimum of 87 octane/87 AKI (91 RON). High altitude
use, see High Altitude.
° Gasoline with up to 10% ethanol (gasohoI) or up to
15% MTBE(methyl tertiary butyi ether) is acceptable.
Avoid pressure washer damage.
Faiiumto foliow Operator's Manuai for fuet
recommendations voids warranty.
DONOTuseunapprovedgasolinesuchas E85.
DONOTmixoil in gasoline.
DONOTmodifyengineto runon alternatefuels.
To protect the fueI system from gum formation, mix in a fue!
stabiiizerwhen adding fueL See Storage.Ali fuei is not the
same. if you experiencestarting or performanceproblems after
using fue!, switch to a different fuel provider or changebrands.
This engine is certifiedto operateon gasoiine.The emission
control system for this engineis EM (EngineModifications).
WARNING
Fueiand its vapors are extremely flammable and
explosive.
Fire or explosion can causesevere burns or
death.
WHENADEmNGFUEL
• TurnpressurewasherOFFand let it coolat least2 minutes
beforeremovingfuelcap.Loosencapslowlyto relievepressure
in tank.
• Fillfuel tankoutdoors.
o DONOToverfilltank.Allowspacefor fuel expansion.
• If fuel spills waituntil it evaporatesbeforestartingengine.
o Keepfuelawayfrornsparks,openflames,pilot lights,heat,and
otherignitionsources.
• DONOTlight a cigaretteorsmoke.
1. Cieanareaaround fuel fiii cap, removecap.
2. Siowiy add regular unleaded fuel (A) to fuet tank (B). Be
carefui not to overfiii. Aiiow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
CAUTION! AIcohoI-blendedfuels (caiied gasohot, ethanol or
methanol) can attract moisture, which leadsto separationand
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engineproblems,the fuel system should be treated
with a fuel preserveror emptiedbefore storage of 30 days or
longer, if adding a fuel preserver, fiii the fuei tank with fresh
fuel. if oniy partiaiiy fiiied, air in the tank wiii promote fuel
deterioration during storage. If fuel preserver is not used,
drainthe fueI tank, start the engineand iet it run untii the fuel
lines andcarburetor are empty. Usefresh fuel nextseason. See
Storagefor additionalinformation.
NEVERuseengine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
Loading ...
Loading ...
Loading ...