Loading ...
Loading ...
Loading ...
8 | Wolf Customer Care 800.222.7820
Preparation
Before moving the range, protect any finished flooring and
secure the oven door(s) closed to prevent damage.
OVEN DOOR REMOVAL
To lighten the load or to fit through a doorway, the oven
door(s) can be removed. Remove only if necessary. Do not
remove the griddle or any other component. Door removal
should be done only by a certified installer or service
technician. Do not lift or carry the oven door by the door
handle.
To remove, open the door completely. Rotate both hinge
locks forward to the open position, remove the screw
closest to the hinge on both sides of the door, and pull the
door forward. Refer to the illustration below.
To reinstall, slide the door onto the hinges. Rotate the
hinge locks back completely and install the screws.
Placement
The range has rear casters which allow for easy movement
by lifting the front of the unit. Do not lift or carry the range
by the oven door handle.
Use an appliance dolly to move the range near the open-
ing. Place the appliance dolly on the side or back to pre-
vent damage. Remove and recycle packing materials. Do
not discard the anti-tip bracket supplied with the range.
If a riser has been specified, refer to the installation instruc-
tions packaged with the riser. The riser must be installed
before the range is installed.
Leveling
Raise the range to its desired height by adjusting the front
legs and rear casters. Use a ⁄" socket to adjust the rear
casters. The front legs can be adjusted by rotating the leg
clockwise to raise and counterclockwise to lower.
IMPORTANT NOTE: For 48" and 60" models, equally
distribute the load to all three front legs and rear casters.
HINGE
LOCK
SCREW
Oven door removal
Installation
Loading ...
Loading ...
Loading ...