Loading ...
Loading ...
Loading ...
Select the wash cycle and options desired. Or press START/
RESUME to use the same cycle and options as the previous
cycle.
A "O" shows the steps that are in each cycle.
Water usage is shown in U.S. gallons/liters.
These models meet the ENERGY STAR®guidelines for energy
efficiency.
Cycle time includes dry time. An asterisk ( * ) by the cycle time,
Main Wash, and Final Rinse indicates the cycle time might be
longer depending on the temperature of the water entering the
dishwasher.
IMPORTANT: Typical cycles may take several hours depending
on water temperature.
Pots Pans
Use this cycle for heavily soiled pots, pans, casseroles, regular
tableware and hard** water conditions.
Use both detergent dispenser sections.
Pre- Main Pre- Final Dry Average Water
Wash Wash* Rinse'i" Rinse* Time* Usage
(min) (gal/L)
• • • • • 125" 6.9-7,8/
140°F 140°F 26-30
(60°0) (60°0)
Normal Wash
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.) During the main
wash cycle, the wash action will repeatedly pause for several
seconds.
Use both detergent dispenser sections.
Pre- Main Pre- Final Dry Average Water
Wash Wash* Rinse1" Rinse* Time* Usage
(min) (gal/L)
• • • • • 110" 4.3-7,8/
115°F 140°F 16-30
(46°0) (60°0)
Light Wash
Use this cycle for china or crystal. This cycle uses a light wash
and gentle dry. During the heated dry, the heating element
cycles on and off.
Use main detergent dispenser section.
Pre- Main Pre- Final Dry Average Water
Wash Wash* Rinser Rinse* Time* Usage
(rain) (gal/L)
• • • • • 105* 4,6-6.8/
115°F 135 OF 17-26
(46°C) (57°0)
A small amount of water is run through the pump to remove
soil particles between the main wash and final rinse.
*If the incoming water temperature is less than the
recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat, and water
as needed.
**Hard water is defined as 7 grains per U.S. gallon and above.
1. Press CANCEL/DRAIN. The Cancel/Drain light glows.
2. The dishwasher starts a 2-minute drain (if needed), Let the
dishwasher drain completely, The light turns off after
2 minutes. The door must be closed for the dishwasher to
drain,
To stop the drain
You can press CANCEL!DRAIN again to stop the drain.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press CANCEL!DRAIN before starting the dishwasher to clear all
options and cycles.
During the first minute ot a cycle
1. Select a new cycle and/or options.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. The Start/Resume light will flash when the door is opened.
Make sure the door is closed.
4. Press START/RESUME.
After the first minute of a cycle
1. Press CANCEL!DRAIN. The Cancel/Drain light glows. Your
dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. Make sure the door is closed. The Start/Resume light will
flash.
4. Select a new cycle and/or options.
5. Press START/RESUME.
12
Loading ...
Loading ...
Loading ...