Loading ...
Loading ...
Loading ...
© 2009
6
24” ADA-Compliant Series Operation / Installation Manual
Mounting bracket
Screw
Lockwasher
Lock strike
Nut
Lock bracket
Lock body
Figure 6. Door Lock - Optional
WOOD OVERLAY INSTALLATION
Before beginning installation, check all components for proper fit and
finish. Also, doors can be reversed to hinge left or right (see page 7
for instructions).
WARNING
• All overlay doors require a trim panel at least 3/4” thick.
• The solid wood overlay panel should not weigh more than 20
pounds.
• The glass wood overlay panel should not weigh more than 10
pounds.
The following instructions cover installing a solid wood overlay or glass
wood overlay panel, handle and optional lock.
IMPORTANT: Contact the factory for full size wood overlay panel
layouts.
Refer to Figure 7 for glass wood overlay door panel.
Refer to Figure 8 for solid wood overlay door panel.
Refer to Figure 9 for solid wood drawer overlay panel.
Door Lock Installation (optional)
When installing to wood overlay, perform lock installation before
mounting wood overlay to door.
1. See Figure 6. Attach mounting bracket to wood overlay.
2. Insert lock body and attach with nut.
3. Install lock strike, lock washer and screw.
4. Use the key to turn the lock and verify that the lock and unlock
positions are correct: unlock should be up, lock should be horizon-
tal. Adjust as necessary.
5. Install overlay with lock assembly to the door.
6. Install lock bracket to the unit.
See Figure 7A, 8A and 9A for door lock placements on panels.
Handle Installation
CAUTION
Handle mounting on wood overlay door should be mounted on
overlay panel only (not the door) to avoid damage to the factory
door.
1. Handle must be attached to overlay before mounting overlay onto
door. Mark rear of wood overlay panel with handle fastening loca-
tions.
2. Drill through wood overlay panel at marked locations taking care
not to damage the wood overlay panel.
3. Countersink screw heads so screw heads are flush with backside
of panel. Attach handle to overlay panel.
Overlay Installation
CAUTION
Proper wood working tools should be used to avoid damage or
errors in workmanship.
1. With the unit secured in position, open the door and make sure
panel pre-drilled holes align with door frame holes.
2. Loosely attach four corners of the overlay panel to the door using
#10 x 1” wood screws, installed through the door frame from the
rear.
3. Check for overall wood overlay panel fit, position and function.
Make minor adjustments as necessary. When panel is properly
aligned, tighten mounting screws securely. Install the rest of the
mounting screws and tighten securely.
CAUTION
Do not overtighten wood overlay attachment screws as this may
damage factory supplied door frame.
Loading ...
Loading ...
Loading ...