Loading ...
Loading ...
Loading ...
Section 2 - OPERATING INSTRUCTIONS
2.2.2, PROPELLING MOWER
(Self Propelled Models Only)
1. Move ground speed control to the desired speed
position. See Figure 2.4.
2, Start engine. Refer to Section "Starting &
Operation".
3. Move wheel drive control against handle to
engage wheel drive and propel mower forward.
Forward speed can be adjusted while the mower is
moving by changing position of the ground speed
control. See Figure 2.4.
MOVE GROUND
SPEED CONTROL TO
DESIRED POSITION
RECYCLING MODEL SHOWN
(ROPE START MOUNTED ON
RIGHT SIDE OF HANDLE)
(FAST)
SIXTH SPEED
POSITION
WHEEL DRIVE
2.3
2,4
BLADE
CONTROL
FIGURE 2,4
STOPPING
Stop engine and blade by releasing the blade
control. Stop forward motion of mower by releasing
the wheel drive control.
HANDLE HEIGHT ADJUSTMENT
The height of the mower handle can be adjusted as
follows:
1, Loosen the lower nuts on each lower handle as
shown in Figure 2.5.
HIGHER
LOWER
HANDLE
2, Move upper mower handle up or down until the
desired position is achieved.
3, Tighten the lower nuts on each lower handle to
maintain desired position.
WARNING A I
STOP engine and mower blade by releasing the blade I
control before adjusting cutting height or handle I
height. I
2,5 CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and move
to desired cutting height. See Figure 2.6.
D LOWEST CUTTING
HEIGHT// _,_
ITI j7
x
FIGURE 2.6
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 6. The lowest
cutting position is Notch 1. See Figure 2.7.
LATCH
POSITIONS
//
LOWER
LOOSEN LOWER
NUTS ON EACH
LOWER HANDLE
FIGURE 2.5
CUTTING HEIGHT SETTINGS
FIGURE 2.7
7
Loading ...
Loading ...
Loading ...