Loading ...
Item No. 0AH-00-001 Revised: 07/24/12
Caution: Turn off electrical power first!
1. Your Air-O Hood has been tested and packaged ready-to-use, requiring no further assembly, only installation.
2. After removing hood from carton, slide out aluminum mesh grease filter.
3. Unscrew and remove the electrical outlet box cover located at the side of the motor compartment.
4. Position hood against cabinet bottom with back against wall. Mark 4 hole locations, then lay hood aside. Drive #10
screws halfway into these locations and remove. If necessary to use furring strips to provide a solid base for
mounting. The bottom of the range hood should be installed a minimum of 30” above cooking surface.
5. For venting Air-O-Hoods, mark the duct hole location on bottom of cabinet or vertical wall and cutout. For round
duct models, install damper in duct collar with butterfly louvers opening upward. For rectangular 3 ¼” x 10” duct
models, reinstall the damper assembly. On back mounted dampers the hinge pivot should be at the top; on top
mounted, the hinge should be in the back.
6. Bring 120 volt power cable through wall or cabinet. Install an approved 7/8” power supply connector (not
furnished).
7. Position hood on 4 screw holes at bottom of cabinet. Bring power cable through connector, and on vented models
seal ductwork over duct collar. Align hood with cabinet and tighten screws.
8. Connect the black wire from the power supply cable to the black wire in the electrical outlet box. Repeat procedure
with the white wires using wire nuts or any other suitable insulated connector. Ground the unit according to local
code. Replace the electrical outlet box cover.
9. On vented models, secure ductwork to collar with sheet metal screws or furnace tape. Be sure the damper shutter
moves freely.
10. Install maximum 60-watt light bulb.
11. Replace filter or filters. Turn on electrical power and your hood is now ready to use.
Loading ...
Loading ...