Loading ...
Loading ...
Loading ...
TESTFORSOLUTIONSPRAY
SeeFigure6
1. Hold Floor Nozzle above floor level.
2. Pull Solution Release Trigger on Angled Wand.
DepressSolutionReleaseTriggerfor30-60secondsuntil
solutionbeginsto/low.
3. Observe Floor Nozzle to make sure cleaning solu-
tion is being sprayed evenly. (seeDETAIL"A" )
NOTE: If solution is not being sprayed evenly, refer
Trouble Shooting Chart.
RELEASE
TRIGGER
FLOOR
NOZZLE
CLEANING THECARPET
See Figures 7 & 8
Solution Dispensing Stroke:
1. Start ata corner (recommended).
2. Place Floor Nozzle so Suction Inlets are flush with
carpet.
3. While exerting light pressure down on Floor
Nozzle, depress Solution Release triggerand slowly
pull Floor Nozzle towards you. DepressSolution Re-
leaseTriggerfvr 30-60 seconds until solution begins to
NOTE: Do not overwet. Ifthree or more cleaning strokes
are required, let dry and then repeat cleaning process.
Solution Recovery Stroke:
I. Release Solution Release Trigger.
2. Lift Floor Nozzle off carpet.
3. ReturnFloor Nozzle to point where you dispensed
cleaning solution and pull across carpet, recovering
dirty solution.
SPRAYS OF
SOLUTION
I,'.
SUCTION INLETS
LIFT,
SET FORWARD,
PULL BACK ACROSS CARPET
\
\
t
!
I
Loading ...
Loading ...
Loading ...