Loading ...
GENERAL INFORMATION
Gas Installation Codes
• Appliance must be used in accordance with the
installation requirements of your gas supply
authority, or the appropriate installation code
issued by Standards Australia AS 5601.
• Appliances for use with bottled gas are labelled
‘propane gas’.
• Only use on a non-combustible surface.
Clearances
Minimum Clearances from combustible materials
must be: Cylinder - 500mm. Wall - 500mm.
Above - 1200mm.
Below - never use on a flammable surface. Only use
on a non-combustible surface.
Hose & Regulator Safety
The regulator and hose assembly supplied with the
appliance are suitable for propane gas only.
The pressure regulator and hose assembly supplied
with the appliance must be used. Replacement
pressure regulators and hose assemblies must be
those specied by the appliance manufacturer.
Only use the hose assembly supplied with this
appliance for direct connection to the cylinder
“DO NOT USE ADAPTORS”.
Check the regulator “O” Ring periodically for
wear or damage and replace if required.
When connecting the hose and regulator assembly
to the gas cylinder, take care to avoid unnecessary
twisting or kinking of the exible hose. Maximum
hose length is 1 metre.
IMPORTANT
• Outdoor use only
• Read these instructions for use carefully.
Familiarise yourself with the appliance
before connecting it to its gas container.
Keep these instructions for future
reference.
• Failure to comply with these instructions could
result in a re or explosion which could cause
serious bodily injury, death or property
damage.
CAUTION: Accessible parts may be very hot.
• Keep young children away.
• DO NOT modify this appliance.
• DO NOT move this appliance during use.
• Turn off the gas supply at the gas cylinder
after use.
• Parts sealed by the manufacturer or their
agent must not be manipulated by the user
• This appliance is only to be used outdoors.
• Never operate this appliance without a
regulator.
• Do not test for gas leaks with an open ame.
• If this information is not followed exactly a re
causing death or serious injury may occur.
• Do not store a spare gas cylinder under or
near this appliance. Never ll the cylinder
beyond 80% full. This appliance is only to be
used and stored outdoors.
• If there is a leak on your appliance (smell
of gas), immediately attempt to turn off the
cylinder valve. Remove the appliance to a
well ventilated location away from any ignition
source. Only check for leaks outdoors using
soapy water. DO NOT try to detect leaks using
a ame.
• Never connect an unregulated gas cylinder to
your appliance.
NOTE: ONLY USE ON A
NON-COMBUSTIBLE SURFACE
2
After the assembly has been secured, turn on the
gas and check for leaks by brushing a soap and
water solution overall connections.
DO NOT USE this appliance if it is leaking, damaged
or does not operate properly.
If you are unable to correct the leak by tightening
the connections, turn off the gas and contact the
supplier immediately.
Always ensure the appliance is kept away from
ammable materials and the gas cylinder clear
of any heat source. When changing over from an
empty gas cylinder to a full one make sure this
procedure is carried out in a well ventilated location,
preferably outside, away from people and away from
any sources of ignition; such as naked ames, pilot
ames, electric heaters/equipment.
Specifications
Appliance specifications can be found on the data
label attached to the appliance body.
Gas Cylinder Use & Safety
This is a low pressure appliance and must only be
used with the hose and regulator supplied. This
appliance shall only be used with propane gas
cylinders certified to AS 2469. It may be hazardous
to attempt to fit other types of gas containers.
The gas cylinder should be lled by a reputable gas
supplier and visually inspected and re-qualied at
each lling.
Always keep cylinder in an upright position. Always
close the cylinder valve when the appliance is not in
use.
Do not subject gas cylinder to excessive heat.
Loading ...
Loading ...
Loading ...