Loading ...
Loading ...
Loading ...
14
BOTTLE, KEG & BACK BAR COOLERS, GLASS & PLATE CHILLERS
OPERATIONS MANUAL
SLIDING GLASS DOOR REMOVAL
AND ADJUSTMENT
All sliding glass doors are easily removable for thorough clean-
ing. To remove the doors, slide the outer door (see Figure
11) open about half way, grasp the door on both sides and
lift straight up, off the bottom of the mounting frame. Tilt the
bottom of the door out, so it clears the frame. Slide the door
towards its closed position, to release tension on the spring-
loaded door closer in the top of the mounting frame. Gently set
the door down in a safe location. Repeat this procedure for the
inner door.
To replace the doors, reverse the steps above, making sure the
pusher on the spring-loaded door closer seats properly against
the top of the door. If your sliding door does not close firmly,
remove the doors, starting with the outer door, as described
above. Check the bottom of the door, mounting frame channel,
and rollers to make sure they are clean and free of debris. If the
rollers are damaged or do not turn freely, contact the factory to
order replacement parts.
IMPORTANT NOTE: The glass used in sliding or hinged
glass doors is special, thermally sealed and cannot be
replaced with ordinary window or plate glass. Replacement
glass can be ordered directly from the factory.
OPTIONAL ACCESSORIES
Continental offers a variety of accessories for your unit.
INSTALLING ELECTRIC CONDENSATE HEATER
The electric condensate heater has a power cord with a 15 amp
plug attached. To install the heater on a KC or BBC model, dis-
connect the power supply by unplugging the cabinet electrical
cord. Remove the grill from the front of the cabinet (see Figure
10) and carefully set it aside. For easier access to the machine
compartments, the louvered end panel can also be removed.
Place the electric heater in the upper machine compartment
as shown and carefully position the end of the plastic drain
tube into the heater pan. Make sure the tubing is not blocked
or kinked and that the end is located securely, so any water
running out of the tube will go into the pan. Route the heater
power cord through to the lower machine compartment. Plug
the cord into the receptacle labeled “vaporizer” located on the
wall between the cabinet and the machine compartment. Secure
any excess power cord with a wire tie, so it is away from hot or
moving parts and does not fall into the pan or under the cabinet.
Reattach the front grill and the end panel. Plug the cabinet elec-
trical cord into the power supply.
IMPORTANT NOTE: It is extremely important to ensure
the condensate heater is plugged into the receptacle
labeled “vaporizer” and that the condensing unit is
plugged into the receptacle labeled “condensing unit.”
FIGURE 11: Sliding Glass Door Components
SPRING-LOADED
INTEGRAL HANDLE
MOUNTING FRAME
BACKBAR SLIDING GLASS DOOR ASSEMBLY
DOOR
(OUTER)
RIGHT HAND
DOOR
(INNER)
HANDLE
INTEGRAL
DOOR CLOSERS
DOOR SEAL
LEFT HAND
DOOR
SEAL
FIGURE 10: Electric Condensate Heater
Loading ...
Loading ...
Loading ...