Loading ...
Loading ...
Loading ...
8
Before Using the Appliance
• Remove the exterior and interior packing.
CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2 hours to
allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure
to do so may adversely affect performance and the lifetime of this unit.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door. (See page 10.)
Installation of your Appliance
• The appliance is designed for built-in, recessed or free-standing installation.
• WARNING: Do not store or install the appliance outdoors.
CAUTION: This appliance is designed for storing and cooling beverages and drinks. Do not store
perishable food, medicine or other medical products.
• Place your Beverage Merchandiser on a floor that is strong enough to support it when it is fully
loaded. To level the unit, adjust the front leveling legs.
• For freestanding installation, 5” (127mm) of space at the back and sides of the unit and 4“
(102mm) at the top are suggested, which allows the proper air circulation to cool the compressor
and condenser for energy saving.
• Even for built-in installation, it is a must to keep at least 3/16” (5mm) of space on each side, 2”
(50mm) at the back and 1/16” (1.6mm) at the top to ensure proper service access and ventilation.
And the air vent at the front of the appliance must never be covered or blocked in any way.
CAUTION: Make sure that the socket and ON/OFF switch are easily accessible after the appliance
has been installed.
• Avoid locating the unit in moist areas.
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other
heating source. Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Do not install in a location where the temperature will fall below 60°F
(16°C). For best performance, do not install the appliance behind a cabinet door or block the
base grille.
• Plug the Beverage Merchandiser into an exclusive, properly grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
Electrical Connection
Loading ...
Loading ...
Loading ...