Loading ...
Loading ...
Loading ...
4
|
• Before beginning, please read these instructions completely and
carefully.
• DO NOT remove permanently afxed labels, warnings, or
plates from product.This may void the warranty.
• All local and national codes and ordinances must be observed.
Installation must conform with local codes or in the absence of
codes, the National Fuel Gas Code ANSIZ223.1 INFPA54.
• The installer must leave these instructions with the consumer
who should retain for local inspector’s use and for future
reference.
In Canada: Installation must be in accordance with the current
CAN/CGA B149.1 & 2 Gas Installation codes and/or local codes.
Electrical installation must be in accordance with the current
CSA C22.1 Canadian Electrical Codes Part 1 and/or local codes.
In Massachusetts: All gas products must be installed by a
“Massachusetts” licensed plumber or gastter. A “T” type handle
manual valve must be installed in the gas supply line to the
appliance.
An air curtain or other overhead range hood which operates by
blowing a downward airow onto the range, shall not be used
with a gas range.
Your safety and the safety of others is very important.
We have provided many important safety messages in this manual
and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to hazards that can kill or hurt
you and others.
All safety messages will be preceded by the safety alert symbol
and the word“DANGER,” “WARNING” or “CAUTION.”
These words mean:
DANGER
Hazards or unsafe practices which WILL result in severe
personal injury or death.
WARNING
Hazards or unsafe practices which COULD result in
severe personal injury or death.
CAUTION
Hazards or unsafe practices which COULD result in
minor personal injury or property damage.
All safety messages will identify the hazard, tell you how to
reduce the chance of injury, and tell you what can happen if the
instructions are not followed.
A GFI shall be used if required by NFPA-70 (National
Electric Code), federal/state/local laws, or local
ordinances.
• The required use of a GFI is normally related to the location
of a receptacle with respect to any signicant sources of water
or moisture.
• SUPERIORE will NOT warranty any problems resulting from
GFI outlets which are not installed properly or do not meet
the requirements below.
If the use of a GFI is required, it should be:
• Of the receptacle type (breaker type or portable type NOT
recommended)
• Used with permanent wiring only (temporary or portable
wiring NOT recommended)
• On a dedicated circuit (no other receptacles, switches or loads
in the circuit)
• Connected to a standard breaker of appropriate size (GFI
breaker of the same size NOT recommended)
• Rated for Class A (5 mA +/- 1 mA trip current) as per UL 943
standard
• In good condition and free from any loose-tting gaskets (if
applicable in outdoor situations)
• Protected from moisture (water, steam, high humidity) as much
as reasonably possible.
WARNING
To prevent possible damage to cabinets and cabinet nishes, use
only materials and nishes that will not discolor or delaminate
and will withstand temperatures up to 194°F (90°C). Heat
resistant adhesive must be used if the product is to be installed in
laminated cabinetry. Check with your builder or cabinet supplier
to make sure that the materials meet these requirements.
Warnings & Important Safety Instructions
Loading ...
Loading ...
Loading ...