Loading ...
Loading ...
Loading ...
Surface CooMng
Placement of Burner Bases and Caps
(Models with seabd burner only)
Your cooktop is equipped with three different sized
burners: Power Burner (large), Standard Burner(medium)
and Simmer Burner (small).
Place the burner base over each gas opening, matching
the burner base size with the gas opening size. Place the
burner cap on each burner base, again matching the cap
size to the burner base size. The cap for the each Burner
has an inner locating ring which locates the burner cap in
the center of the burner.
i
Gas
7 Opening
Make sure each
burner cap is
properly aligned and
bvel.
Turn the burner on to
determine if it will
light, if the burner
does not light,
contact a Sears
Service Center. Do
not service the
seabd burner
yourself.
Electrode
SeamedBurner
Setting Surface Controls
The surface control knobs shown be-
low may not look identical to the Sur-
face Controls Knobs on your range;
They are only representational,
Venturi (open) Burner Models
To Adjust Low or "Simmer" Setting (some models)
The burner flame, at low setting, can be adjusted if it is too high ortoo low; refer
to the Installation instructions for adjustment procedure.
To operate the Surface Burner:
1. Place cooking utensil on burner.
2. Push inand turn the Surface Control knob to LITE. Note: All electronic ignitors
will click at the same time. However, only the burner you are turning on will
ignite.
3. Visually check that the burner has lit.
4. After the burner lights, turn the control knob to the desired flame size. The
control knobs do not have to be set at a particular mark. Use the guides and
adjust the flame as needed. DO NOT cook with the control knob in the LITE
position. (The electronic ignitor will continue toclick ifleft inthe LITE position.)
Loading ...
Loading ...
Loading ...