Loading ...
Loading ...
Loading ...
TOLEVELMOWERHOUSING
Adjustthemowerwhiletractorisparked
onI_velgroundordriveway.Makesure
tiresareproperlyinflated(See"PROD-
UCT SPECIFICATIONS" section of this
manua0. If tires are over or
underinflated, you will not properly adjust
your mower.
SiDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• At the midpoint of both sides of mower,
mea_ura height from bottom edge of
mower to ground. Distance "A" on
both sides of mower should be the
same or within 1/4" of each other.
• If adjustment is necessary, make
adjustment on one side of mower only.
• To raise one side of mower, tighten lift
link adjustment nut on that side.
• To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each full turn of adjustment nut
will change mower height about 1/8".
• Recheck measurements after adjust-
ing.
Bottom Edge of Bottom Edge of
M_r to GroundA_-_7_ "Mower toiroun d
Measure distance "D" directly in front and
behind the mandrel at bottom edge of
mower housing as shown.
• Before making any necessary adjust-
ments, check that both front links are
equal in length. Both links should be
approximately 10-3/8".
• If links are not equal in length, adjust
one link to same length as other link.
• To lower front of mower loosen nut "E"
on both front links an equal number of
turns.
• When distance "D" is 1/8" to 1/2" lower
at front than rear, tighten nuts "F"
against trunnion on both front links.
• To raise front of mower, loosen nut "F"
from trunnion on both front links.
Tighten nut "E" on both front links an
equal number of turns.
• When distance "D" is 1/8" to 1/2" lower
at front than rear, tighten nut =F"against
trunnion on both front links.
• Recheck side-to-side adjustment.
°o_ I ° o/ Mandrel
o o o
BOTH FRONT LINKS MUST BE EQUAL
IN LENGTH
Suspension
C_,\/ Arm
o@
iftLink
__ Nut
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to-
side.If the following front-to-back adjust-
ment is necessary, be sure to adjust both
front links equally so mower will stay
level side-to-side.
To obtain the best cutting results, the
mower housing should be adjusted so
that the front is approximately 1/8" to 1/2"
lower than the rear when the mower is in
its highest position.
/
/
Front Trunnion
Links
•Nut "E"
22
Loading ...
Loading ...
Loading ...