Kenmore Elite 11045962400 Front-Loading Automatic Washer

Owner's Manual and Installation Instructions - Page 13

For 11045962400. Also, The document are for others Kenmore models: 110.4596*, 110.4597*

PDF File Manual, 68 pages, Read Online | Download pdf file

11045962400 photo
Loading ...
Loading ...
Loading ...
To begin the wash cycle immediately
Select and hold START (for approximately 1 second).
If you do not select START within 5 minutes of choosing a
cycle, the washer automatically shuts off.
When the wash cycle is complete, the CLOTHES CLEAN
status light glows, the door unlocks, and the wash load
can be removed from the washer. The washer powers
down automatically 5 minutes after the cycle is complete
and the CLOTHES CLEAN light goes off. To power down
the washer manually after the wash cycle is complete,
select PAUSE/CANCEL once.
To begin the wash cycle later
Select DELAY until the desired delay time (in hours) shows in
the Estimated Time Remaining display. Select START. The
countdown to the wash cycle will show in the display window.
Your new washer has a dispenser drawer with three separate
compartments for your laundry products--one is for detergent, one
is for liquid chlorine bleach, and one is for liquid fabric softener.
Laundry products are diluted and dispensed automatically at the
proper time during the wash cycle, making it unnecessary for you
to return to the washer during the cycle to add them.
It is normal for small amounts of water to remain in the
dispensers when the wash cycle is complete.
Do not put laundry additives directly into the wash tub. Always
use the proper dispensers when adding laundry products.
Choosing the Right Detergent
Use only High Efficiency detergents. The package for this type of
detergent will be marked "HE" or "High Efficiency." This wash
system, along with less water, will create too much sudsing with a
regular non-HE detergent. Using regular detergent will likely result
in washer errors, longer cycle times, reduced rinsing performance,
and may result in component failures and noticeable mold or
mildew. HE detergents are made to produce the right amount of
suds for the best performance. Follow the manufacturer's
instructions to determine the amount of detergent to use.
To fill dispenser compartments
1. Pull out the dispenser drawer.
2. Add the desired laundry product to the proper compartment.
3. Push in the dispenser drawer slowly and completely (to avoid
a spill).
D
Dispenser
A. Dispenser release lever
B. Separator
C. Main Wash detergent compartment
D. Liquid chlorine bleach compartment
E. Fabric softener compartment
Main Wash detergent compartment
(Letter C in Dispenser Illustration)
Add liquid or powdered HE detergent to this compartment for
your wash cycle. The detergent separator must always be in
place, either in the front or back position.
When delaying a cycle, use only powdered detergents in the
main wash compartment since liquid detergents may seep
out of the compartment during Delay, before the wash cycle
begins.
Do not fill beyond the "MAX" level.
Liquid or powdered color-safe bleach may be added to the
Main Wash detergent compartment along with the same type
of detergent, liquid or powdered.
Liquid detergent: Put the separator in the front position,
between the guides, as shown following. There will be no gap
between the bottom of the wash cycle detergent
compartment and the bottom of the separator.
[] POWDER
LIQUI
SO
Separator in front position, between guides
A. Separator
B. Guide
Powdered detergent: Put the separator in the back position,
behind the guides, as shown following. There will be a gap
between the bottom of the wash cycle detergent
compartment and the bottom of the separator.
A. Separator
B. Guide
L
LIQU
SC
NOTE: The separator will be in the powder (back) position when
shipped from the factory.
13
Loading ...
Loading ...
Loading ...