Loading ...
Loading ...
Loading ...
FIG. 8
(4)
9. OPERATING THE SHREDDER
– 11 –
9.1 START UP OPERATION – FIG. 6
1. Select Forward/Reverse by pressing switch (3).
2. Press the On/Off switch (1) to ON (I) postion to
start the motor.
3. Press the On/Off switch (1) to OFF (O) postion to
stop the motor.
CAUTION:
Damage to the machine due to improper operation.
Incorrect handling can result in machine damage.
Only feed materials to be shredded after the machine
was switched on. Do not feed materials to be
shredded after the machine was switched off.
NOTE:
The machine is equipped with a safety switch to
prevent it from being switch on again accidentally
after a power failure.
9.2 OVERLOAD PROTECTION – FIG. 7
This machine is equipped with an overload protection
system. To protect the motor from being damaged,
the safety switch will automatically switch off the
power when the motor is overloaded.
Wait at least 1 minute before restarting by first
pressing the reset button and then the On/Off switch.
If the motor does not restart, do the following :
1. Press the safety switch(2).
2. Press the Forward/Reverse Button (3) to
REVERSE position.
3. Press and hold the On/Off switch (1)to ON (I)
position to remove any objects that could obstruct
the blades.
ATTENTION:
Always wear safety gloves when executing the steps mentioned above.
9.3 USING THE PLUNGER – FIG. 8
There is a plunger provided to aid feeding less bulky
material such as small twigs, leaves, other garden
waste and vegetation into the in-feed chute.
1. Load the material into the hopper.
2. Insert the plunger (4)into the in-feed chute
pushing the material onto the blade disc.
3. Wait until all the material has been shredder
before adding more material.
NOTE:
Your fingers must never enter the in-feed chute.
Never use the tool if the hopper is not fitted.
Do not over reach.
FIG. 6
(3)
(1)
FIG. 7
(2)
(3)
(1)
Loading ...
Loading ...
Loading ...