Loading ...
Loading ...
Loading ...
i
Cyde Signal Control (some models)
When the Cycle Signal Control isON, a signal will sound at the end of each cycle
and during the PressSaversetting (some models). Thevolume isadjustable on some
models.
Drum Light (some models)
A dru m light will come on whenever the door isopened to illuminate the dryer dru m
during loading and unloading. Closing the door turns off the light.
Placethe front bar under
the lip of the lint screenopening
Reversible Dryer Door
Your dryer isequipped with a reversible door. The door can be hinged on the right
or left side. Refer to tile INSTALLATIONINSTRUCTIONSfor directions on changing
tile door.
Drying Rack (some models)
Use the drying rack to dry items which should not betumble dried.
1. Open the dryer door and remove the lint screen.
2. Insert drying rack into tile dryer drum. Placetile front bar under the lip of the
lint screen opening.
3. Place items to be dried on top of the rack. Weight should not exceed !0 Ibs.
Leavespace between items, but do not let items hang overthe sidesorthrough
the grids. Do not tumble other items when using the drying rack.
4. Select a timed dry setting best suited for items being dried. Useonly the Air Fluff
(no heat) temperature setting for items containing plastic, foam rubber, rubber-
like materials, feathers or down.
5. When items are dry, remove the rack and replace the lint screen. If lint screen
is not in place, tumbling items could enter the exhaust system and cause
damage to tile dryer.
i
Common Drying Problems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage.
Forsatisfactory drying results, follow these suggestions provided byTile Soap and Detergent Association.
Greasy, oily
stains
Lint
POSSIBLE CAUSES PREVENTIVE MEASURES
• Fabricsoftener sheet, , Rubfabric softenerstainswith bar soap, , Add a few bathtowels to smallloadsfor
Rinseand rewash, proper tumbling
Some "silkdike" fabrics should be air dried,
Useproper drying temperature_
Placefabric softenersheeton top of load
before starting the dryer
Donot overloaddryer
Usefabric softenerin washer or dryerto
reducestaticelectricity
Removeitemswhen they are slightlydamp
to avoidoverdrying.
Checkthat lint screeniscleanand in place.
Pilling
(Fibers break
off, ball up and
cling to fabric.)
Shrinking
Wrinkling
Overloading_
Overdrying causes static
electricity.
Lint screen not clean
when cycle begam
Lint is attached to "pills_"
Reduceload size and rewash using liquid .
fabric softener in the final rinse_
Or, add afabric softenersheetand
tumble without heat
Uselint brushor rollerto removelint,
Pilling is normal with
synthetic and permanent
press fabrics This is due
to abrasion from normal
wear_
Use a lint brush or shaver to remove pills.
Use fabric softener to lubricate fibers
When ironing, use spray starch or fabric
finish on collars and cuffs_
Turn items inside out to reduce abrasion
Overdrying
Overloading.
Leaving items in dryer
after cycle ends
Irreversible condition
Reduce load size and tumble at medium
or low heat for 5-10 minutes_
Remove items immediate[y_ Hang or fold.
Follow fabric care label directions
If shrinking is a concern, check load often.
Remove items while slightly damp and
hang or lay fiat to complete drying_
Block knits into shape
Do not overload dryer
Remove items as soon as cycle ends
Loading ...
Loading ...
Loading ...