Loading ...
Loading ...
Loading ...
14
WATER PRESSURE
Minimum inlet water pressure is 0.04MPa
Maximum inlet water pressure is 1.0MPa
NOTE:
The new hose-sets supplied with the appliance are to be used
and that old hose-sets should not be reused.
WATER CONNECTION
Connect the water supply hose to a threaded 3/4”connector.
During operation, the dishwasher will heat up the appliance to the required temperature
so please be sure that the hose it not kinked or squashed and tightly fastened in place.
If the hose is new or has not been used be sure to
let the water run for a little bit to
clear the hose of any impurities.
SAFETY SUPPLY HOSE
The safety supply hose consists of the double walls. The hose’s system guarantees its
intervention by blocking the flow of water in case of the supply hose breaking and
when the air space between the supply hose itself and the outer corrugated hose is
full of water.
HOW TO CONNECT THE SAFETY SUPPLY HOSE
1. Pull The safety supply hoses completely out from storage
compartment located at rear of dishwasher.
2. Tighter the screws of the safety supply hose to the faucet
with thread 3/4inch.
3. Turn water fully on before starting the dishwasher.
HOW TO DISCONNECT THE SAFETY SUPPLY HOSE
1. Turn off the water.2. Tighter the screws of the safety
supply hose to the faucet
2. Unscrew the safety supply hose from the faucet.
A hose that attaches to a sink spray can burst if it is installed on the same
water line as the dishwasher. If your sink has one, it is recommended that
the hose be disconnected and the hole plugged.
GETTING STARTED (Cont.)
Loading ...
Loading ...
Loading ...