Loading ...
Loading ...
Loading ...
Assembly
1. Remove the pole xing nut (16) from the main pillar (14) and insert the main pillar
(14) into the base (15) then tighten the xing nut (16).
2. Release xing screw B (13) and adjust height to a suitable length. Re-tighten the
xing screw B once ready.
3. Release the xing screw A (11), connect the motor housing with the upper pillar
(12), fasten it with the xing screw A (11).
4. Remove the blade locking cap (2) and the guard knob (4) from the motor shaft
(6), secure the rear guard (5) on the motor housing (9) to line up with the three
xing pins, fasten the guard with the guard knob (4).
5. Put the blade (3) on the motor shaft (6) and tighten with the blade locking cap
(2).
6. Attach the front guard (1) to the rear guard (5), and close the guard xing clips,
nally fastening with the safety screw (17)
1. Connect the plug to a power supply and switch on the power.
2. Switch the fan ON by rotating the speed control knob (7) at the rear in clockwise
direction.
3. The switch is also used to adjust the fan SPEED.
4. The airow direction can be adjusted upward/downward by lifting up or pressing
down the motor housing.
NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your
ngers through the guard.
5. Push the oscillating knob (8) down to start OSCILLATION. Pull the oscillation
knob up to stop OSCILLATION.
6. Turn speed control knob (7) to adjust the fan speed from LOW ”1” – MEDIUM ”2”
- HIGH ”3” in sequence. Turn the switch anti-clockwise to the “0” position to turn
OFF.
7. Turn the switch anti-clockwise to the “0” position to turn the fan OFF. Speed
Operation
7
Loading ...
Loading ...
Loading ...