Loading ...
Loading ...
Loading ...
6
Installation Instructions
Parts List
Remove all packing materials and parts. Inspect to make sure all parts listed below are
present and in good condition:
1 double draft arm assembly (with washer)
1 CO
2
cylinder
1 CO
2
regulator
2 keg taps (American Sankey type)
1 cleaning kit
Vinyl tubing
1 stainless steel (removable) floor to protect the unit during keg insertion
1 drip tray
Hose clamps
Various screws
Before Using Your Appliance:
Remove the exterior and interior packing.
Before connecting the unit to a power source, let it stand for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surfaces of the unit with lukewarm water using a soft cloth.
Installing the Kegerator:
Place the unit on a floor that is strong enough to support the appliance when it is fully loaded.
To level the unit, adjust the two leveling legs at the front.
Your appliance is designed to be either built-in or free-standing in indoor or outdoor settings.
Take care that the air vents at the front of the appliance are never covered or blocked in any
way. For optimum performance, it is recommended to keep ¼” space on each side and at the
top, as well as 2” in the back.
Locate the unit away from direct sunlight and sources of heat (oven, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extremely cold ambient temperatures may also affect the unit's performance.
Avoid locating the unit in moist areas. Too much moisture in the air will cause frost to form
quickly on the evaporator, requiring more frequent defrosting of the interior.
Plug the unit into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or
authorized service center.
Loading ...
Loading ...
Loading ...