Loading ...
Loading ...
Loading ...
2. Using 2 - #10 - 12 x 11/2"slot-head wood screws, secure the
tray-frame assembly to the wall opening.
Left Side
A. #10 - 12x 1_" slot-head wood screw
Right Side
A
3=
4.
With tray center pushed away from the windowsill, place a
level on the angled edge on top of the tray side. Be sure level
is against notch on tray side.
A.Angled edge on top of the trayside
B.Notch
Adjust SMART-MOUNT _tray until bubble indicates the
angled edge on top of the tray side is level.
IMPORTANT: The tray must slope downward slightly toward
the outside to provide proper drainage for the air conditioner.
A.#10 - 12x 1_" slot-head wood screw
NOTE: If the exterior of building can be damaged by support
legs, place a board between the wall and support legs.
5=
6.
7.
A. Bubble indicates the angled edge on top of the tray
side isleveL
B.Place levelon angled edge againstnotch on trayside.
Tighten the hex nut just enough to hold tray center in place.
Repeat with other side.
Tighten hex nuts securely with 7_6"wrench.
• Handle air conditioner gently.
• Be sure your air conditioner does not fall out of the opening
during installation or removal.
• Do not block the louvers on the front panel.
• Do not block the louvers on the outside of the air conditioner.
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
Place the air conditioner in the SMART-MOUNT ° tray. Check
that feet on bottom of air conditioner are resting on the 3/4"
(1.9 cm) x 2" (5 cm) wood strip at the bottom of the wall
opening and the top channel rests against the top of the wall
opening.
-JX,i
A J
LJ
A. SMART-MOUNT ®tray
B. Feet on bottom of air conditioner resting on wood strip
13
Loading ...
Loading ...
Loading ...