Loading ...
Loading ...
Loading ...
iNSTALL FLUE MOUNTING BRACKET
(DUCTED AND NON-DUCTED HOODS)
1. Assemble the flue mounting bracket, adjusting outside width as shown. See Figure 8.
2. Carefully center the mounting bracket directly over the range hood location.
3. Secure the bracket assembly to the ceiling using (2) 4.8x38mm mounting screws and drywall anchors (Fig. 9). Make sure
the bracket is pushed into the corner, tight against the wall and centered over the hood.
FLUE MOUNTING BRACKET
3.9 x 6 mm
FLAT HEAD
BRACKET SCREWS
/
(265.6 mm)
DRYWALL ANCHORS
4.8x38mm
MOUN_NG SCREWS
PREPARE THE HOOD
Note: On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood
and decorative flues, prior to final installation.
DUCTED HOODS ONLY
1. Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Fig. 10.
2. Install the discharge collar into the duct connector of the range hood. Fig. 11.
ELECTRICAL
SYSTEM
PLATE
PROTECTION
DUCT
CONNECTOR_
-6-
Loading ...
Loading ...
Loading ...