Loading ...
Loading ...
Loading ...
5
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packaging.
Before connecting the appliance to the power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door, if it is not already attached (See page 7).
INSTALLATION OF YOUR APPLIANCE
Your outdoor drawers’ refrigerator has been designed for both built-in and free standing. When
built-in, your refrigerator drawers do not require additional air space for top, side, or rear, the
front grille must NOT be obstructed.
Note: It is recommended that you do not install the appliance near an oven, radiator, or other heating
source. And heat sources may increase electrical consumption. Don’t install in a location where the
temperature will fall below 50°F (10°C). For best performance, do not install the appliance behind a
cabinet door or block the base grille.
Avoid locating the unit in moist areas.
Plug the appliance into an exclusive, properly grounded wall outlet.
SITE PREPARATION
1. Position the unit on a flat, level surface capable of supporting the entire weight of the unit.
Remember the unit will be significantly heavier once it is fully loaded.
2. Avoid connecting the unit to a Ground Fault Interrupter (GFI). GFIs are prone to nuisance
tripping which will cause the unit to shut down. GFIs are generally not used on circuits which
power equipment that must run unattended for long periods of time.
3. The unit must be installed according to your local codes and ordinances.
4. ELECTROCUTION HAZARD!
Loading ...
Loading ...
Loading ...