Loading ...
Loading ...
Loading ...
1312
Should your electric blanket fail to heat, check
the following:
1. Check that the controls are properly
connected to the blanket and clicked
securely into position. If you find the
control connector plug is not properly
fitted to the blanket, switch the power off
at the power outlet, securely attach the
control connector plug to the blanket, and
then switch the power back on. The timer
indicator light should not flash once the
power is reconnected. If the timer light
flashes once the power is reconnected,
the control connector plug is not properly
fitted.
2. Check that the power cord is connected to
the power outlet and the power is switched
on.
3. Check that the control slide switch is in
either the 75 minute or 12 hour position.
Troubleshooting - 6 heat digital timer control
If the control detects a fault within the
blanket, the standby light (
) will flash.
If the standby light flashes twice, followed
by a long pause, the control may not be
connected to the blanket correctly. Turn the
control off at the main power switch (located
on the rear of the control). Check that the
control is properly connected to the blanket
and the connector is not damaged. Switch
the control on again. If the standby light
continues to flash, please contact Sunbeam
Customer Service (see the back page for
contact details).
If the standby light flashes three times,
followed by a long pause, the blanket is to
hot or may be damaged. Turn the control off
at the main power switch (located on the rear
of the control). Switch the control on again.
If the standby light continues to flash, please
contact Sunbeam Customer Service (see the
back page for contact details).
All Sleep Perfect electric blankets feature
waterproof heating elements, making them
fully immersible and safe to wash by hand or
machine.
Before cleaning your electric blanket, ensure
that the controls are unplugged from the
blanket.
Spot cleaning
Sponge the affected area using a neutral
wool detergent or mild soap flakes mixed with
lukewarm water. Sponge twice with clean
water to remove detergent. Remove excess
water by compressing the wet area between
two towels.
Hand washing
Wash the blanket in lukewarm water with a
neutral wool detergent or mild soap flakes.
Soak for five minutes, then gently squeeze
the soapy water through the fabric. Rinse
thoroughly in clean, lukewarm water then
drain excess water from the blanket. Do not
wring.
Machine washing
Take your electric blanket to a commercial
laundry or wash in a domestic washing
machine (size permitting). Wash on WOOL
or DELICATES cycle with a neutral wool
detergent or mild soap flakes, below 40°C.
Do not use high speed or extra spin cycles.
Line drying
Drape the blanket across several lines of your
clothesline. Do not use pegs on the wired
areas. Do not dry with a hairdryer or heater.
Ensure that the blanket and control sockets
are completely dry before using again.
Machine drying
Tumble dry your blanket on LOW setting for
15 minutes MAXIMUM. Smooth the blanket
by gently pulling any creases out of the
fabric. Line dry to ensure the blanket and
control sockets are completely dry before use.
Do not dry with a hairdryer or heater.
Storing your blanket
Your blanket can remain on the bed all year
round as a comfortable underblanket. Simply
remove the controls and store until winter.
If you wish to remove the blanket from your
bed when not in use, roll or fold it loosely
and store in a blanket bag or the bag it was
supplied in. Avoid pressing sharp creases into
the blanket.
Do not place heavy items on top of your
electric blanket when storing.
When storing the electric blanket, allow it to
cool down before folding.
Troubleshooting Care and cleaning
Loading ...
Loading ...