Loading ...
Loading ...
Loading ...
ImportantSafetyInstructions
mMPORTANT mNSTRUCTmONS FOR USmNGYOUR
OVEN
. Use Care When Opening Oven Door or Warmer Drawer (if
equipped)--Stand to the side of the range when opening the door
of a hot oven, Let hot air or steam escape before you remove or
replace food in the OVER,
Keep Oven Vent Ducts Unobstructed. The oven vent is located
under the left rear surface element if your model is equipped with
col elements. The oven vent is Iocated below the backguard for
models equipped with ceramic-glass cook tops. Touching the
surfaces in this area when the oven is operating may cause
severe burns. Also, do not piace plastic or heat-sensitive items
on or near the oven vent. These items could melt or ignite.
,,Pmacement of Oven Racks. Always place oven racks in desired
location while oven is cool. If rack must be moved while oven is
hot use extreme caution. Use potholders and grasp the rack with
both hands to reposition. Do not let potholders contact the hot
heating elements in the oven. Remove nil utensils from the rack
before moving.
,,Do not use the broiler pan without its insert. The broiler pan and
its insert allow dripping fat to drain and be kept away from the high
heat of the broiler.
Do not cover the broiler insert with aluminum foil Exposed fat
and grease could }gn{te.
,,Protective Liners--Do not use aIuminum foiI to line the oven
bottom. Only use aluminum foil as recommended in this manual.
Improper installation of these liners may result in risk of electric
shock, or fire.
mMPORTANT mNSTRUCTmONS FOR CLEANmNG
YOUR RANGE
,_CBean the range regularly to keep a/parts free of grease that
could catch fire. Pay particular attention to the area underneath
each surface element. Do not allow grease to accumulate.
,_Kitchen cmeaners and aerosols--Amways follow the
manufacturer's recommended directions for use. Be aware
that excess residue from cleaners and aerosoIs may ignite
causing damage and injury.
,_OCeanVentlating Hoods Frequenty--Grease should not be
allowed to accumumate on the hood or filter. Follow
manufacturer's instructions for cleaning.
COIL COOK TOP MODELS
,_Make Sure Reflector Pans or Drip Bowls Are in Prance--Absence
of these pans or bowls during cooking may subject wiring or
components underneath to damage.
,,Protective Liners--Do not use aluminum foil to ire surface unit
drip bowls, or reflector pans. Only use aluminum foil as
recommended in this manual. Improper insta/ation of these
liners may result in risk of electric shock, or fire. Improper
instalation of these liners may result in risk of electric shock, or
fire.
IMPORTANT SAFETY NOTICE
The California Safe Drinking Water and Toxic Enforcement Act
requires the Governor of California to publish a list of substances
known to the state to cause cancer, birth defects or other reproductive
harm, and requires businesses to warn customers of potential
exposure to such substances.
The ELement ON mndicator Light
The Coil Cook Top range is equipped with a surface control light that will glow on your range--
the Element ON indicator light, The Element ON indicator light (all models) located on the
control panel, will glow when any surface element is turned ON, A quick glance at this light after
cooking is an easy check to be sure all surface controls are turned OFF,
Oven Vent Location
For models equipped with coil surface elements, the oven vent is located under the teft
rear surface element. When the oven is on, warm air flows through the left rear
element. This venting is necessary for proper air circulation in the oven and good baking
results. DO NOT BLOCK THE OVEN VENT.
Arranging Oven Racks
OVEN VENT LOCATED _1
UNDiR LEFT REAR ELENENT 1
, j
c
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERA -!ING THE OVEN). Always use oven
mitts when using the oven.
Removing & Replacing Oven Racks
To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on
the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Loading ...
Loading ...
Loading ...