Kenmore 10689482990 ice cube maker

User Manual - Page 14

For 10689482990.

PDF File Manual, 48 pages, Download pdf file

Loading ...
Loading ...
Loading ...
10. Replace water pan by pushing back on the bottom
with one hand while pushing up and back on the top.
Secure the water pan by replacing both screws.
11. Check the following:
Drain cap from the water pan is in place.
Hose from water pan is inserted into storage bin
drain opening.
12. Slide the cutter grid back into place and secure it by
replacing the right-hand screw and plastic spacer.
Then tighten the left-hand screw. Reconnect the cutter
grid and ice level sensor harnesses.
13. Plug in ice maker or reconnect power.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
To shut down the ice maker:
1. Unplug ice maker or disconnect power.
2. Remove all ice from storage bin.
3. Shut off the water supply.
4. Remove the two screws in the lower access panel and
the two screws from the base grille area of the front
panel support. Pull forward to remove the lower access
panel.
5. Disconnect the inlet and outlet lines to water valve.
Allow these lines to drain and then reconnect to the
valve.
6. Replace lower access panel and screws.
7. Drain water from water pan by removing the drain cap.
8. If the room temperature will drop below 32 ° F (0° C),
remove water from the drain line.
For ice makers with a drain pump installed:
a) Plug in ice maker or reconnect power.
b) Turn ice maker off and remove all remaining ice from
ice bin.
9.
c)
Pour 1 quart of water into the ice bin near the drain
and let the unit stand for approximately five
minutes. This will allow the water in the bin to drain
into the drain pump so that the pump will remove
the remaining water from the ice bin and the drain
pump.
d) Unplug ice maker or disconnect power.
Before using again, clean the ice maker and storage
bin.
10. Plug in ice maker or reconnect power.
NOTE: All components of the ice maker are permanently
lubricated at the factory. They should not require any
additional oiling throughout the normal life of the machine.
14
Loading ...
Loading ...
Loading ...