Loading ...
Loading ...
Loading ...
Yourpressurewasherrequiressomeassemblyandis
readyforuseonlyafterit hasbeenproperlyserviced
withtherecommendedoil andfuel.
If you haveanyproblemswith theassemblyof
your pressurewasher,pleasecallthe pressure
washerhe_plineat 1-800-222-3136.
REMOVE PRESSURE WASHER
FROM CARTON
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
• Remove fillers, accesories and parts bag shipped
with your pressure washer.
• Roll pressure washer out open end of carton.
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• The main unit
Handle
Accessory tray
Spray gun
High pressure hose
Nozzle extension with quick connect fitting
Engine oil
Parts bag (which includes items listed below)
• Operator's manual
• Registration card
• Bag containing 4 multi-colored ProjectPro TM
nozzles
• Fresh Start TM fuel cartridge
• Handle fastening hardware kit (which includes):
• Carriage bolt (2)
• Plastic knobs (2)
• Tree Clips (4)
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 6. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBUNG YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect ProjectPro TM nozzle to
nozzle extension.
Attach Handme and Accessory Tray
1. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
Handle '1', _/
Align Hoes I::_ ¢_/>
Handlei
// Supports/
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.
3. Place accessory tray over holes on handle
(viewing from front of unit). Push tree clips into
holes until they sit flat against accessory tray.
.
i
TMI
TM_%. )
//
/
/
.... /
Insert multi=colored ProjectPro TM nozzles and
other supplied accessories in spaces provided in
accessory tray. See "How to Use Accessory Tray".
Add Engine Oi_
CAUTmON! Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
1. Place pressure washer on a level surface.
2. Clean area around oil fill and remove oil dipstick.
3. Using oil funnel (optional), slowly pour entire
contents of provided oil bottle (18 oz.) into oil fill
opening.
Loading ...
Loading ...
Loading ...