Loading ...
Loading ...
Loading ...
4. SlidetheGroundingBracket(107)ontooneofthe
HandrailSpacers(65)inthelocationshown.
SeeinsetdrawingA.PinchthetabsontheGrounding
Bracket(107)sothatthetabswillfitintotheholeinthe
Upright(69[seeinsetdrawingB]).
SeeinsetdrawingB.PlacetheHandrailSpacer(65)on
theleftUpright(69)asshown,withthecutoutontheindi-
catedside.Note:Makesurethatthetabsonthe
GroundingBracket(107[seeinsetdrawingB])arein-
sertedintotheholeintheUpright.
5. PulltheUprightWireHarness(98)upthroughtheother
HandrailSpacer(65).PlacetheHandrailSpaceronthe
rightUpright(69)asshown,withthecutoutturnedtoward
thetreadmill(seeinsetdrawingA).
HaveasecondpersonholdtheHandrails(66)nearthe
Uprights(69)asshown.ConnecttheUprightWire
Harness(98)tothewiresextendingfromtheConsole
Base(81).InserttheconnectorsandtheUprightWire
HarnessintotheholeintheConsoleBase(seeinset
drawingB).
SettheHandrails(66)ontheHandrailSpacers(65),
beingcarefulnottopinchtheUprightWireHarness(98).
z
-<
A
Tabs
81
81
6. Insert two Handrail Bolts (78) with Handrail Washers
(77) and Handrail Bushings (75) into the right Upright
(69) and the right Handrail Spacer (65). Turn the
Handrail Bushings so they fit against the Upright with
the thick sides of the Bushings toward the center of the
treadmill as shown in the inset drawing. Lift the right
Handrail (66) slightly and align the Bolts with the holes
in the Handrail. Next, thread the Bolts into the Handrail.
Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (78).
75
"_ 77
77 78
Thick
Side
7. Make sure that all parts are tightened before you use the treadmill. Note: If there is a thin sheet of clear
plastic on the hood decal or the "ComforTrack" decal, remove it. Keep the included allen wrench in a secure
place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet from
damage, place a mat under the treadmill.
Loading ...
Loading ...
Loading ...