Loading ...
Loading ...
Loading ...
Installing Your Refrigerator
How to Adjust the Temperature Controls
This refrigerator is designed to operate at a household temperature of 55 ° to 110°F (13 ° to 43 ° C).
I Locate refrifferator and
freezes" controls on upper
left wall of refrifferator
section, and set both
controls to 3 ½.
Dial Temperature Control Models
For initial temperature setting, follow all five steps listed below. If doing a simple
ternperature rnodification for an operational unit, only steps 3 through 5 are required.
3Check to see if freezer
ten_lJeratlzre is 0 ° to 2° F (-17 °
to -ld ° C).
• Turn control to next highest
number if too warm.
IMPORTANT: Neither section
will cool if freezer control is
set to Off.
• Turn control to next lowest number
if too cold.
• Allow 5 to 8 hours for adjustments
to take effect.
4Check to see that refri_rerator
section is 38 ° to 40 ° F (3 ° to
4° C).
Turn control to next highest
number if too warm.
Turn control to next lowest number
if too cold.
Allow 5 to 8 hours for adjustments
to take effect.
Repyt:teps ,,s ]
necess£1Ey,
How do I perform a
temperature test
with my dial '
temperature
controls?
IMPORTANT: These instructions
apply to dial temperature controls
only. Electronic control models Ii||
constantly monitor unit
temperature on the controls
M_teti_ls xweded
2 thermometers measuring -5°
to 50°F (-21° to 10°C) |
2 drinking glasses
For Freezer
Place thermometer in glass of
vegetable oil in middle
of freezer and continue
with step 3 of How to Adjust
the Temperature Controls
section.
IMPORTANT: Due to design of
unit, always start temperature
adjustments with freezer section,
For Refrigerator
Place thermometer in glass of
water in middle of unit and
continue with step 3 of How to
Adjust the Temperature
Controls section.
Electronic Temperature Control Models
I To set tenlperature of the J'eezet) use tile "_" buttolls next to the
@ button. A settinff ofO ° to 2°F (-17 ° to -16 ° C) is recommended.
Use the _4. button to raise the temperature of the freezer section, or the .y, to
lower it.
Press the _ button to confirm the settings.
To s'et tile tezlTper_lttlre of tile fresh food seetion_ use the ^
T_ SE_
v
buttons next to the _ button. A settinff of 38 ° to 40° F
0
(3 ° to 4 C) is reommend_d.
Use the A button to raise the temperature of the fresh food section, or the v
to lower it.
• Press the $I_,_ button to confirm the settings.
r3 All°w 24 h°urs 'br temf°erattH'es t° s_'_xbiljze" 1
_' NOTE: If adjusting the temperature of an operational unit, only 5 to 8 hours is |
required for temperatures to take effect.
Why do the
temperatures on my
LED display
fluctuate after they
have been set?
The compartment temperatures
may vary slightly as the unit cycles
to maintain the set temperatures.
Loading ...
Loading ...
Loading ...