Loading ...
RX
10 s
IMPORTANT SAFETY INFORMATION
1. Read and understand the instructions and safety guide completely
before using the product.
2. Ensure both the instruction manual and safety guide are accessible to
all users, including when passing the product on to third parties.
3. Only use this product with
autho
rised RØDE accessories.
4. Do not open the product housing. This will void the warranty.
5. Refer all
service and repairs to RØDE-approved
s
ervice personnel.
Service or repair is required
for produ
c
t
s that have been damaged,
e
xposed to liquid, rain or moisture, or do not operate normally.
6
. Use the product only in the ways described in the instructions.
7
. Do not use the product if
i
t
was
damaged during transportation.
8
. Keep the product away from liquids and electrically conductive objects
that are not necessary for operati
on.
9. Do not use any solvents or corrosive cleaning agents to clean the
product.
10. Do not adjust the controls of the pr
o
duct in an environment that
requires your attention (operating machinery, driving etc.).
NORTH AMERICA
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. This
device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d' en compromettre le fonctionnement.
Regulatory information such as identification numbers are displayed on the
Wireless GO II receiver by pressing the Gain and Power buttons simultaneously
for at least three seconds. To dismiss this screen, simply press any button on
the receiver.
EU COMPLIANCE STATEMENT
RØDE Microphones hereby declares that the Wireless GO II transmitter and
receiver are in compliance with Radio Emissions Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available at
http://www.rode.com/wireless/wirelessgoII.
For details of EU Representative go to rode.com/distributors.
Frequency Range: 2.402 – 2.480 GHz
Transmission Power: < 10mW
식별 번호와 같은 규제 정보는 적어도 3 초 동안 게인 및 전원 버튼을 동시에 눌러
Wireless GO II 수신기에 표시됩니다. 이 화면을 닫으려면 수신기의 아무 버튼이나
누르기 만하면됩니다.
SOUTH KOREA
硽疩ֵአᘏ礚Ꭳᒫ殻虻懱ԏ砺֢ྍ詽褖ӣ㮆砺֢ྍ詽
憙ێ狒虁蘻承物ֵአ螂ଶ盳㰁疏憙ێ
憙ێ狒虁ဳԪ殻物
Lֵአ獤楮藶ջ௳獤楮牐
LL๚笕䵇ଞ㱾犋蓦癷䵇犥Ӥྯ蓦癷犋ᥝ᩻螂碻牐
犵ۑሲ疤毱襎秚蘻承物犵ۑሲ疤毱襎秚螕አ妿ࣳୗ藨挨ݳ໒ԏ犵ۑሲ疤毱襎秚牧覍妿战
ݢ牧獍ݪ牏珶蒈ֵአᘏ璂犋ᛔ虋ๅ毱ሲ牏ےۑሲ虋ๅܻ戔懯ԏ粬现ۑ胼牐犵
ۑሲ疤毱襎秚ԏֵአ犋段汜膠獊现ଗ硑ݳဩ蝢מ牪妿咳匍磪ଗ硑匍虡碻牧䛑缏ܨ؊
አ牧㪔硬珿ᛗ篷ଗ硑碻ො媣媲ֵአ牐獮殻ݳဩ蝢מ牧瞲狅襎מဩ憒֢禂ԏ篷娄襎蝢מ
牐犵ۑሲ疤毱襎秚殾盚ݑݳဩ蝢מૡ禂牏ᑀ䋊现蠴ዌአ襎ူᬊ疤襎秚戔猋ԏଗ硑牐
襎穥獊ፘ橕ဳԪ殻牐
5V 0.3A
EUROPE
USA
CANADA
AUS/NZ
TAIWAN
POWER
TAIWAN
ݶ碻ೲӥʼnፅŊʼn襎რŊೲ衔ᛗӣᑁ楮牧ܨݢࣁ:LUHOHVV*2,,矑硩瑊Ӥ氥纈拙ই秂蘷蒈
ԏ觊ጱဩ憒מ௳牐ᥝ橕樂種癷牧ݝ襑ೲ矑硩秚Ӥጱ犨֜ೲ衔ܨݢ牐
7
TX
8
RX
9
Love your Wireless GO II?
Share with us #rodemic
rode.com
Scan the
QR code to
find out more
rodemic
@
rodemic
@
rodemics
ID: R-R-R72-Transmitter
Company Name: RØDE Microphones
Model: Wireless GO II - Transmitter
Country of Origin: Australia
JAPAN
Transmitter ID:
Receiver ID:
Transmitter ID:
Receiver ID:
Transmitter ID:
Receiver ID:
2AEAN-WGOIITX
2AEAN-WGOIIRX
20091-WGOIITX
20091-WGOIIRX
Transmitter: 204-B00279
Wireless GO II - Transmitter
ID: R-R-R72-Receiver
Company Name: RØDE Microphones
Model: Wireless GO II - Receiver
Country of Origin: Australia
視力保護警語：使用過度恐傷害視力
REGULATORY & SAFETY
규정 및 안전 지침
CCAM20LP2910T2
CCAM20LP2900T2
Receiver: 204-B00280
Wireless GO II - Receiver
A
B