Loading ...
Loading ...
Loading ...
18
MAINTENANCE
Before cleaning or carrying out maintenance operations, discon-
nect the equipment by removing the plug or switching o the
main switch.
Do not use detergents containing abrasive, acidic or corrosive substances
or abrasive cloths.
Regular maintenance guarantees proper operation and performance over time.
Special attention is to be paid to the metal anti-grease lters : frequent clean-
ing of the lters and their supports ensures that no ammable grease is accu-
mulated.
CLEANING OF EXTERNAL SURFACES
You are advised to clean the external surfaces of the hood at least once every
15 days to prevent oily substances and grease from sticking to them. To clean
the brushed stainless steel hood, the Manufacturer recommends using "Magic
Steel" wipes.
Alternatively and for all the other types of surfaces, it can be cleaned using a
damp cloth, slightly moistened with mild, liquid detergent or denatured alcohol.
Complete cleaning by rinsing well and drying with soft cloths.
Do not use too much moisture or water around the push button
control panel and lighting devices in order to prevent humidity
from reaching electronic parts.
The glass panels can only be cleaned with specic, non-corrosive or non-abra-
sive detergents using a soft cloth.
The Manufacturer declines all responsibility for failure to comply with these in-
structions.
CLEANING OF INTERNAL SURFACES
Do not clean electrical parts, or parts related to the motor inside
the hood, with liquids or solvents.
For the internal metal parts, see the previous paragraph.
METAL ANTI-GREASE FILTERS
It is advised to frequently wash the metal lters (at least once a month) leaving
them to soak in boiling water and cleaning solution for 1 hour, taking care not to
bend them. Do not use corrosive, acid or alkaline detergents.
Rinse them well and wait for them to be completely dry before reassembling
them. Washing in a dishwasher is permitted, however, it may cause the lter ma-
terial to darken: to reduce the possibility of this problem from happening, use
low-temperature washes (55°C max.).
To extract and insert the metal anti-grease lters see the gure.
LIGHTING
The range hood is equipped with high eciency, low consumption LED spot-
lights with an extremely long life-span under normal use conditions.
Should the LED spotlight need to be replaced, proceed as shown in the gure.
12V
3
1
2
CARBON AND ZEOLITE FILTERS
Under normal use conditions, we recommend that:
regenerated every 18 months and replaced after 3 years.
To regenerate part C:
- Remove the lter as described in the instructions.
- Wash part C in the dishwasher with a normal detergent at a temperature of
65°C maximum.
- Dry in the oven at 80°C for 20 minutes.
- Once part C has dried, ret part Z and insert the lter into the hood.
- The maximum life of part C is 2/3 years with 10 washings a year max.
To regenerate part Z:
- Remove the lter as described in the instructions.
- Simply place part Z in a domestic oven at a temperature of 200°C for approxi-
mately 2 hours.
- Once part Z has cooled down, ret part C and insert the lter into the hood.
Light on/o
Short impulse:
turn light on and o
Long impulse: change light tone from 2700K to 5600K
TIMER (red LED ashing)
Auto switch-o after 15 min.
The function deactivates (red LED o) if:
- The TIMER key ( ) is pressed again.
- The ON/OFF key ( ) is pressed.
FILTER ALARM (red LED steady on with ( ) o)
Anti-grease lter maintenance after approximately 30 hours of oper-
ation. Press ( ) the meter for 3 seconds to reset.
Loading ...
Loading ...
Loading ...