Loading ...
Loading ...
Loading ...
Connecting the Water Supply
(select models)
Materials Needed
'4" outer diameter flexible copper tubing
Shut-off valve (requires a X" hole to be drilbd into
water supply line before valve attachmenO
o Adjustabb wrench
° '4" hex nut driver
Add 8' to tubing bngth needed to reach water
supply for creation of service loop.
Create service loop with copper
tubing {minimum 2' diamete0.
Avoid kinks in the copper tubing
when bending it into a service
bop.
2' diameter
Remove plastic cap from water valve inlet
port.
Phce brass nut (A) and sbeve (B} on
copper tube end as illustrated.
Reminder: Do not use an old
sbeve.
B
Place end of copper tubing into
water valve inbt port. Shape tubing
siighdy. Do not kink - so that tubing feeds
straight into inlet port.
Slide brass nut over sleeve and screw nut
into inlet port. Tighten nut with wrench.
@
IMPORTANT: Do not overdghten. Cross
threading may occur.
Pu[[on tubing to confirm connection is
secure. Connect tubing to frame with
water tubing clamp (C} and turn on
water supply. Check for leaks and
correct if necessary. Continue to
observe the water supply connection
for two to three hours prior to moving
the refrigerator to its permanent
location.
7. Monitor water connection for 2/4 hours. Correct
leaks, if necessary.
Loading ...
Loading ...
Loading ...