Loading ...
Loading ...
Loading ...
10D-Link DGS-1016D/DGS-1024D User Manual
Section 2 - Safety Instructions
Electrical Power Guidelines
• Operate the product only from the type of external power source indicated on the electrical ratings label. If unsure of the
type of power source required, consult a service provider or local power company.
• The purpose of this product is to create a constant network connection for your devices. As such, it does not have a
standby mode or use a power management mode. If you wish to power down this product, please simply unplug it from
the power outlet.
To help avoid damaging the system, be sure the voltage selection switch (if provided) on the power supply is set to match
the local power available. Also be sure that attached devices are electrically rated to operate with the local power available.
• 115 volts (V)/60 hertz (Hz) in most of North and South America and some Asian countries such as South Korea
and Taiwan
• 100 V/50 Hz in eastern Japan and 100 V/60 Hz in western Japan.
• 230 V/50 Hz in most of Europe, the Middle East, and the Far East.
• Use only approved power cable(s).
• If a suitable power cable has not been provided for the system or any AC-powered option intended for the system, purchase
a power cable that is approved for use in the country of use. The power cable must be rated for the product and for the
voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cable should
be greater than the ratings marked on the product.
• To help prevent an electric shock, plug the system and peripheral power cables into properly grounded electrical outlets.
These cables are equipped with three-prong plugs to help ensure proper grounding. Do not use adapter plugs or remove
the grounding prong from a cable. If an extension cable must be used, use a 3-wire cable with properly grounded plugs.
• Observe extension cable and power strip ratings. Make sure that the total ampere rating of all products plugged into the
extension cable or power strip does not exceed 80 percent of the ampere ratings limit for the extension cable or power strip.
Loading ...
Loading ...
Loading ...