Loading ...
Loading ...
Loading ...
I ABOUT+YOURCOOKTOP
IGNITION SYSTEM +
Your cooktop will feature either pilot ignition or pilotless
Ignition. If the gas supply to the range is turned off, be
sure all controls are set in the OFF position before
re-supplying gas to the appliance.
HOW TO LIGHT SURFACE BURNERS
CAUTION: If the flame should go out during a cooking
operation, turn the burner off. If gas has accumutated and
a strong gas odor is detected, open a window and wait 5
minutes for the gas odor to disappear before relighting
burner.
Pilot Ignition
When the range isfirst installed, the pilots may be difficult
to light due to air in the gas line. To bleed off air from the
line, hold a lighted match next to the burner and turn knob
on. When the burner lights, turn the knob off and proceed
as directed below,
To light pilot: Raise cooktop and hold a lighted match
near the pilot ports. There are two pilot ports.
To prevent damage to the €ooktop or pan, never operate
surface burner without a pan in place, never allow a pan
to boil dry and never operate a surface burner on HIGH
for extended periods of time.
To light surface burner:
1. Place a pan on the burner grate.
NOTE: The burner flame may lift off the burner head
and a "roaring" sound may be heard if a pan is not
placed on the grate before lighting the burner.
2. Push in and turn knob to the LITE position.
Pilotless ignition models only: A clicking sound will
be heard and the burner wilt light. When one burner is
turned on, all ignitorswill spark.
Pilotless Ignition
Pilotless ignition uses a spark from the ignitorto light the
burner. There are two ignitorsfor conventional surface
burners. Once the burner lights, turn the knobto the
desired setting. The clickingsound wilt not stop untiIthe
knob isturned from the LITE position. Once the burner
lights, turn the knob to the desired setting. The clicking
sound will not stop until the knob is turned from the UTE
position.
In the event of a power failure, the surface burner can
be manually lighted. Be sure all controlsare in the OFF
position. Hold a lighted match to the desired surface
burner head. Push in and turn knob to the L1TEposftion.
The burner will then light. Adjust the flame to the desired
flame size.
3. After the burner lights, turn the knob to the desired
flame size.
Pilotless ignition models only: The ignitors will
continue to spark until the knob is turned from the LITE
position.
Adjust the flame size so it
does not extend beyond
the edge of the cooking
utensil. This is for
personal safety and to
prevent possible damage
to the apptiance, pan, or
cabinets above the
appliance. This also improves cooking efficiency+
Loading ...
Loading ...
Loading ...