Loading ...
Loading ...
Loading ...
10
Reversible Door
Instructions (Cont.)
G05I0115
Refrigerator Door
8. To remove handle: Remove the two screws
attaching the handle to the top of the refrigerator
door. Swing the top of handle away from the door
and slide handle down and off of dovetail button.
Remove screw and dovetail button and install on
other side moving hole plugs from corresponding
holes to the opposite side. Reverse instructions
for reattaching handle. Start with handle offset
away from the door. Place bottom of handle over
dovetail button, swing handle into an upright
position and push downward, locking it into
place. Secure top of handle with screws.
Trim Removal (Full-Length Trim models only)
In some models, the refrigerator door has a
full
length trim piece which continues from the bottom
of the handle to the bottom of the door. The top
of the trim fits into the base of the handle. An
adhesive "trim lock" is positioned about half-way
down. The bottom of the trim is held in place by
either an adhesive trim lock, or a trim lock with
two prongs inserted into a hole on the face of the
door. Remove the trim by gently pulling the trim
lock areas out and away from the door. When the
trim is free from the door, gently pull the trim
down and away from the base of the handle.
To reattach trim: Slide both trim locks out of
trim. Insert the new adhesive trim locks contained
in your literature pack. NOTE: Trim lock must be
removed and installed by sliding OVER the two
donut shaped areas. Install trim to handle by
sliding under base of handle. Carefully align trim
and press down at trim lock locations. Replace
hole plug on opposite side. Use rubbing alcohol to
remove any adhesive residue from old trim lock
location(s).
G05I0066
G05I0100
Hinge Pin
Washer
Lower Hinge
Bolts
or
9. Using a putty knife, remove black plastic plug
(not shown) from front of base and reinstall in the
opposite set of lower hinge holes. Assemble lower
hinge to cabinet. Install hinge pin in opposite hinge
hole from which it was removed. Install the washer
(some models) on the lower hinge pin and insert
hinge bolts, but do not tighten. Hinges will have to
remain loose against cabinet to align door.
G05I0107
10. Turn center hinge upside down and secure to
cabinet as shown, using the screws which are in
the new holes. Install refrigerator door on lower
hinge pin. Align door with edge of cabinet. Hold
the door on front of cabinet.
G05I0105
11. Place original washer (some models) over
hole in refrigerator door and line up hole in center
hinge. Insert hinge pin through both holes. Place
washer (some models) on hinge pin, then position
freezer door on center hinge.
G05I0071
Bearing Plug
12. Remove plug from upper bearing of door
and reinstall on opposite side.
Screws
Hinge
13. Assemble upper hinge to top of cabinet and
door. Use opposite set of holes. Do not
completely tighten screws. Align doors so there
is a parallel gap between doors. Adjust doors to
cabinet so gaskets seal, but do not bind. Tighten
upper and lower hinge screws. Additional
adjustment may be necessary after loading the
door shelves. Return food, bottles, and other
articles to doors. Turn the refrigerator control
on, and to the previous setting.
Loading ...
Loading ...
Loading ...