Loading ...
Loading ...
Loading ...
8 9
NOTE
- In case you want to speed up the defrosting, you may put a bowl of warm water (about 122°F / 50°C) into
the refrigerator.
- Do not heat the evaporator directly with hot water or hair dryer while defrosting. Doing so will damage the
freezer compartment.
- Never use a sharp or metallic instrument to remove frost as it may damage the refrigerator and puncture
the cooling coils. It will also void the warranty. We recommend using a plastic scraper.
ENERGY SAVING TIPS
• The refrigerator should be located in the coolest area of the room, away from heat-producing appliances or
heating ducts, and out of direct sunlight.
• Let hot foods cool to room temperature before placing in the refrigerator. Overloading the refrigerator
forces the compressor to run longer and thus increase energy consumption. Foods that refrigerate too slowly
may lose quality or spoil.
• Be sure to wrap foods properly, and wipe containers dry before placing in the refrigerator.
• The shelves should not be lined with aluminium foil, wax paper, or paper towels. This will interfere with cold
air circulation, making the refrigerator less efficient.
• Organize food to reduce door openings and extended searches. Remove as many items as needed at one
time, and close the door as soon as possible.
CARE AND CLEANING (cont.) TROUBLESHOOTING GUIDE
You can solve many common appliance problems easily, saving you the cost of a possible service call. Try
the suggestions below to see if you can solve the problem before calling the servicer.
Refrigerator does not work
A. Refrigerator is not switched on. Turn on the temperature control dial. It may be in the OFF, “0” position
B. Unit is not plugged in or plug is loose. Plug in the refrigerator.
C. Fuse has blown or is defective. Check fuse, replace if necessary.
D. Wall power socket is defective. To be corrected by a qualified electrician.
The food is too cold
Temperature is not properly adjusted. Set the temperature control dial to a warmer setting.
The food is too warm
A. Temperature is not properly adjusted. Set the temperature control dial to a cooler setting
B. Door was open for an extended period. Open the door only as long as necessary. Check door gasket for
proper seal.
C. A large quantity of warm food was placed in the refrigerator within the last 24 hours. Set the temperature
control dial to a colder setting temporarily.
D. The refrigerator is near a heat source. Please look in the “Protection From Heat and Moisture” section.
Heavy build-up of frost, possibly also on the door seal
NOTE This is normal during high humidity periods. Frequent door openings will also cause heavy frost
buildup.
Door seal is not .air-tight (possibly after reversing the door). Carefully warm the leaking sections of the door
gasket with a hair dryer (on a cool setting). At the same time, shape the warmed door seal by hand such that
it sits correctly.
Popping or cracking sounds
When compressor comes on. This is a normal sound of coolant flowing through condenser coils.
Refrigerator door does not shut properly
The refrigerator door is not properly aligned. Re-align the refrigerator door. Refer to the “Door Alignment”
section. Ensure nothing is blocking the door.
Refrigerator has an odor
A. Foods not properly sealed. Remove any contaminated foods.
B. Interior needs cleaning. Please refer to “Cleaning and Care” section.