Loading ...
Loading ...
Loading ...
11
Getting Started
Charging the batteries
(using adaptor)
a. Lift the charge socket cover located on
the top of the handset.
b. Insert the USB connector into the
socket on the top of the radio.
c.Plugthemainsadaptorintoa230V
AC, 50Hz main socket with the switch
on the socket set to Off.
d. Use only the power adaptor listed in
the user instruction.
Then switch ON the main socket.
Battery meter
The battery meter is located in the left corner of the LCD screen.
It appears like a battery with three bars inside. These indicate the
amount of power available. When the battery level reaches its
minimum level, the unit will emit two beep tones and automatically
it will power off.
Your UHF2500 can detect the battery charge in 4 levels;
Battery charge at high level.
Battery charge at medium level.
Battery charge at low level. At this level, the radio will emit
a “beep” sound for every 10 seconds in standby mode.
TIP: At this stage, you need to recharge the unit at
once, otherwise the battery will run down totally.
Battery charge at very low level. When the battery level
reaches its minimum level, the unit will emit two beep tones
and automatically turn off the power.
Important: You need to charge the unit for approximately
14 hours.
CAUTION: Risk of explosion if battery is replaced by
an incorrect type. Dispose of used batteries
according to local regulations.
Mic/spk jack
Charge jack
Loading ...
Loading ...
Loading ...