Loading ...
Loading ...
Loading ...
20 21
ASSEMBLY
Install the suction pipe and shoulder strap
1. Insert the suction pipe into the device and screw into place. (Fig. C)
2. Hook the shoulder strap onto the device as shown. (Fig. D)
OPERATION
OPERATION
Charging the battery pack
NOTE:
Remove the battery pack from the charger after it has been fully charged.
NOTE:
Battery should be fully charged before first use.
NOTE:
Make sure the mains voltage is the same as rating label which is located on the
charger.
1. Connect the charger to a power supply. Red LED will light up.
2. To insert the battery pack into the charger, align the raised ribs of the battery pack with
the grooves of the charger then push it in. (Fig. E)
3. The red LED light of the charger will light up followed by green flashing light during the
charging.
4. After charging is complete, the charger light will turn to a solid green light.
5. Once the battery is fully charged, depress the battery release button and then remove
the battery pack.
Power indicator (See Fig. F)
This Li-Ion battery pack is equipped with a power indicator which is used to show the battery
packs remaining charge. Press the power indicator button to check battery charge as picture
shown. The indicator will stay lit for approximately 4 seconds.
To obtain the best life from the battery
1. Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down
or the tool no longer performs a task it previously performed.
2. Avoid conducting short charges. Make sure that the battery is fully charged each time by
allowing the charger to complete its full charging cycle.
3. Avoid allowing loose items like screws or nails etc. to be stored with battery packs as
these or similar items can short battery packs and cause a fire or explosion.
4. Always unplug the charger when not in use and store in a dry and secure place.
5. Avoid charging or storing your battery in temperatures below 5°C and above 45°C.
6. After use, allow the battery pack to cool down for approximately 30 minutes before
attempting to recharge.
To insert the battery pack (Fig. G)
1. Align the groove on the battery pack with the corresponding ribs in the receptacle of the
device.
2. Insert the battery pack with moderate force until it locks in to place.
WARNING: Only use Yard Force 20V original battery pack!
To remove the battery pack from the tool
1. Press the battery pack release button. (Fig. H)
2. Remove the battery pack from the tool. (Fig. I)
Check before starting!
DANGER! Risk of injury! The device must only be put into operation if no faults are found. If
any part of the device is defective, it must be replaced before the next use.
Check the safety equipment and the safe condition of the device.
– Check all parts to make sure they fit tightly.
– Check whether there are visible defects: broken parts, cracks, etc.
Attaching the collection bag (Fig. J)
1. Hook the front of the collection bag to the device as shown.
2. Insert the nozzle of the collection bag as far as it will go into the device
– Ensure that the bag has slotted into place securely.
Selecting the operating mode
– Set adjustment lever to vacuum [A] or blowr [B]. (Fig. K)
– When using as a leaf vacuum: insert the collection bag as shown into the device and ensure
that it clicks into place.
– When using as a leaf blower: press the unlocking button and remove the collection bag.
Switching on and off (Fig. L)
– Set the On/Off switch to position [1–5] to switch the appliance on.
– Set the On/Off switch to position [0] to switch the appliance off.
Note: Work with leaf blowers/vacuums may not be performed during normal quiet hours.
Setting the blower or vacuum speed
– Set the On/Off switch to the required blowing or vacuuming speed.
Loading ...
Loading ...