Loading ...
Loading ...
Loading ...
: i ΒΈΒΈ/ :--::,; :/ s : ; = -; ...... : : - ::
To avoid injury from accidental starting, always turn switch OFF and unp{ug the too! before moving, replacing the blade
or making adjustment. ....... : ....
Consult your Sears service Center if for any reason the motor will not run.
TROUBLESHOOTING GUIDE - MOTOR
PROBLEM
Brake does net
stop blade within
6 second&
PROBLEM CAUSE 1 SUGGESTED CORRECTIVE ACTION
1,Motor brushes not
sealed or lightly
sticking.
2.Motor brake
overheated from use
of defective or wrong
size blade or rapid
ON/OFF cycling,
3,Arborboltloose.
4.Other.
1.Fuse
1. Inspect ! clean f replace brushes. See
MAINTENANCE section.
2. Use a recommended blade,
Let cool down.
& Retighten arbor boll,
4. Sears Service Center.
Motor does not 1.Use & check t 5-Amp time delay fuse, or circuit
start breaker.
2. Brush worn. 2. See MAINTENANCE section_
3. Other. 3.Sears Service Center.
Excessive brash 1.Fuse 1_Replace Brushes,
spark when 2. Brush worn.
switch released. 3. Other.
TROUBLESHOOTING GUIDE - SAW OPERATION
PROBLEM PROBLEM CAUSE SUGGESTED CORRECTIVE ACTION
Blade hits table. 1. Misalignment. 1. See ADJUSTMENT section.
2. Sears Service Center
Angle el cut not 1. Miler table locked. 1.,Push positive stop locking lever clown and
accurate, rotate table.
Can't adjust miter. 2. Sawdust under table. See OPERATION Section,
2, Vacuum or blow out dust,
WEAR EYE PROTECTION,
1. Loose pivot points. 1. See ADJUSTMENT Section,
1. Sears Service Center.
2. Sears Service Center,
Cutting arm
wobbles,
Cutting arm won't
fully raise, or
blade guard won't
fully close.
Bladebinds, jams,
g_rn$woad,
Saw vibrates or
shakes.
1. Part failure.
2. Pivot spring not
replaced propedy after
service.
3. Sawdust build-up.
1,,Improper operation.
2. Dull blade_
3. Improper blade size_
4, Warped blade.
1.Saw blade not round,
2.Saw blade damaged.
3.Saw blade loose.
4.Other.
3. Clean and lubricate moving parts.
1 SeeBASIC SAW OPERATION section,
2. Replace or sharpen blade.
3, Replace with 10" diameter btade.
4. Replace blade.
t_Replace blade.
2,Replace blade.
3.Tighten arbor screw.
4.SearService Center.
23
Loading ...
Loading ...
Loading ...