Loading ...
Loading ...
Loading ...
wolfappliance.com | 9
Electrical Connection
The terminal block on the back of the range allows for a
3-wire or 4-wire installation. Remove the terminal block
cover to expose the screws with corresponding numbers.
Refer to the illustration below. Route the wires through the
strain relief and to the terminal block.
THREE-WIRE INSTALLATION
1 Connect green/ground to position one.
2 Connect red/L2 to position three.
3 Connect black/L1 to position four.
4 Tighten the screws on the strain relief and install the
terminal block cover.
FOUR-WIRE INSTALLATION
1 Connect green/ground to position one.
2 Connect red/L2 to position three.
3 Connect black/L1 to position four.
4 Install a wire nut on the white/neutral wire.
5 Tighten the screws on the strain relief and install the
terminal block cover.
Door Alignment
To adjust door alignment, follow these steps:
1 Remove the skirt by extracting the screws.
2 Open the door, and loosen the nut. Refer to the
illustration below.
3 Close the door, and turn the screw clockwise to raise
and counterclockwise to lower the door.
4 Open the door, and tighten the nut.
5 Close the door, and reinstall the skirt.
NUT
SKIRT
ADJUSTMENT
SCREW
Door alignment
6 5 4 3 2 1
Electrical connection
Installation
Loading ...
Loading ...
Loading ...