Loading ...
Loading ...
Loading ...
Page 31
SPIDER AND INSECT WARNING
Spiders and other insects can nest in the burner of this and any other burner, which causes the gas to flow from the
front of the burner. This dangerous “condition” can cause a fire behind the valve panel, damaging the burner and
making the burner unsafe to operate. Inspect the burners before each use. Symptoms of insect nests can include
any of the following conditions:
1) The smell of gas in conjunction with the burner flames appearing yellow.
2) The burner does not reach temperature.
3) The burner heats unevenly.
4) The burner makes popping noises.
NOTE: Make sure each burner is properly placed after cleaning. It is very important to ensure the end of the burner is
installed appropriately onto the gas valve to ensure gas flows safely into the burner. Failure to meet these conditions can
cause dangerous conditions that can cause personal injury and/or property damage.
Optional Infrared Sear Burner
How to Replace Conventional Burner with Infrared Sear Burner (A video for installing the infrared sear burner is
located on the blaze website to assist with the below instructions, www.blazegrills.com )
1. To install the optional infrared burner, begin by removing the far left cooking grid, flame stabilizing grid and
zone divider.
2. Remove conventional burner by first removing the cotter pin that holds it in place (unless they were
removed prior to installation), located on the bottom rear of the burner and accessible from the rear outside
of the grill body. With the cotter pin removed, remove the conventional burner.
3. Place the infrared burner in place, leaving off the flame tamer. Ensure the burner is seated appropriately
around the valve so that gas flows into the burner.
4. Replace the heat zone divider and cooking grid. Do not use this burner with the flamer tamer reinstalled
above the burner.
Note: It is critical that the end of the infrared burner is installed appropriately onto the gas valve to ensure gas flows safely
into the burner. For additional information, contact us at 866-976-9510 or go to Blazegrills.com.
Preheating the Infrared Burner
Always preheat the entire appliance before cooking. If the appliance is already hot from cooking, you should still preheat
the infrared burner for 3 minutes with lid open. Never place food over the burner until it is fully preheated to avoid clogging
Loading ...
Loading ...
Loading ...