Loading ...
Loading ...
Loading ...
7
Maintenance
Before inspection and maintenance of the unit. PLEASE set power switch to “OFF” to cut off the
power supply.
3.1
Unit s
3.2 Filters
CAUTION
● Indoor unit, Outdoor unit and Remote controller
● Front panel
1. Wipe them with dry soft cloth.
1.
Open the front panel.
1. Open the front panel.
2. Remove the air filter.
Slide the two stoppers on the left and right sides inward until they click.
2. Remove the front panel.
• Remove the string.
• Allowing the front panel to fall forward will enable you to remove it.
3. Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the front panel with water,dry it with cloth, dry
it up in the shade after washing.
4. Attach the front panel.
• Insert the front panel into the grooves of the unit (3 places).
• Press the claws on the right and left of the air filter down slightly, then
pull upward.
3. Take off the Titanium Apatite Photocatalytic Air-Purifying
Filter.
• Hold the tabs of the frame, and remove the claws in 4 places.
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury
• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully
• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
• For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing compound,
scrubbing brushes, nor other hand stuff.
After cleaning, make sure that the front panel is securely fixed.
.
.
•
• Attach the string to the right, inner-side of the front grille.
• Close the panel slowly.
String
Place front
panel in
grooves.
OPERATION INSTRUCTIONS
String
Loading ...
Loading ...
Loading ...