Loading ...
Loading ...
Loading ...
-9-
-10-
WHERE TO USE:
The Sunbeam
®
GoHeat
®
Standard Patches can be used for common muscle aches and pains.
The Sunbeam
®
GoHeat
®
Deluxe Patch can be used for common joint pain.
Battery:
1. The battery can last up to 8 hours of runtime when using 1 patch on the low heat setting.
The runtime will reduce when using 2 patches or at higher heat setting.
2. The battery light indicator will turn red or green when the battery is either low, charging,
or fully charged. (see table 1 for the battery light colors per setting)
3. Battery runtime will reduce over time. Battery life depends on usage and storage
conditions.
HOW TO CLEAN:
1. Disconnect unit from power source and patch from control unit.
2. Do not wash or submerge in water.
3. Use a dry cloth to spot wipe the control unit.
4. If patch becomes wet or soiled, discard and replace.
5. Do not use chemicals to clean product.
increased blood flow to the skin and dilation of the capillaries. After use, your skin may
be slightly red and warm to touch. This redness should fade over time. CAUTION: If
discomfort, persistent redness or skin irritation occurs, discontinue use.
ii. If at any point, the temperature feels too hot, select lower temperature setting or
discontinue use.
4. There are heat-setting lights on control unit to indicate if the unit is set to low, medium or
high. (see figure 4 for light locations)
5. Use the control unit button to select heat settings by clicking consecutively to scroll
through each setting. (see figure 4 for button location)
After Use
1. Place patches onto plastic films that states, “Store patch here, after use” with the gel side
facing film.
i. Each patch will last up to 10 times. Discard patch when gel no longer sticks to skin.
Refill patches sold separately. (Sunbeam Models: 804-RFL2P and 804-RFL3P)
2. Wrap connector cords around control unit for neat and tidy storage.
3. If needed, recharge control unit prior to next use – only use the power supply that was
provided with the unit.
4. Store unit and patches in cool dry location between use.
Low Heat Light Medium Heat Light High Heat Light
Control Unit Button:
Control Heat Settings
Battery Light
Figure 4
Note: If all 3 Heat Setting lights are flashing, a fault has occurred. Press the power button
to shut down the control unit and try a new patch. If flashing lights persist, discontinue use
and contact warranty services.
Solid Red Control Unit has low Battery<20%
Flashing Red Control Unit has very low Battery<10%
Flashing Green Control Unit is charging
Solid Green Control Unit is fully charged
One Time Flash of Green Control Unit has power, but patches aren’t connected
No Lights Battery is adequately charged
Table 1:
Battery Light Indicator:
Patches Starter Kit_804-STR2P_805-STR3P_18EM4.indd 9-10 11/14/18 1:42 PM
Loading ...
Loading ...
Loading ...