Loading ...
Loading ...
Loading ...
4
Important Safety Information
Electric shock and fire hazard:
• Do not expose this unit to rain or moisture.
• Do not use the unit if it is wet or damaged.
• Use test leads or accessories that are appropriate for the application. Refer to the category and
voltage rating of the test lead or accessory.
• Inspect the test leads or accessory before use. They must be clean and dry, and the insulation
must be in good condition. Destroy test leads and replace immediately if the contrasting inner layer
of insulation is visible.
• Use this unit for the manufacturer’s intended purpose only, as described in this manual. Any other
use can impair the protection provided by the unit.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• The test leads supplied with this product comply with IEC 61010-031:2008, UL 61010-031:2010
and CAN/CSA-C22.2 NO. 61010-031A-07–Amendment 1:2010. These safety standards limit the
exposed length of the probe tip to 4 mm for measurement categories III and IV. These test leads
include a cap that must be in place when used in measurement category III or IV applications.
• Do not apply more than the rated voltage between any two input terminals, or between any input
terminal and earth ground.
• Do not contact the test lead tips or any uninsulated portion of the accessory.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Do not operate with the case open.
• Before opening the case, remove the test leads from the circuit and shut off the unit.
Failure to observe these warnings could result in severe injury or death.
Loading ...
Loading ...
Loading ...