Loading ...
Loading ...
Loading ...
mnstaliation mnstructions
REVERSING THE DOOR SWING (CONT.)
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remove it b) ,grasI)ing, it
about 6" fl'om each end and pulling its bottom edge
toward _ou,
Using a Torx': dfive_; move the bottom hinge bracket
and plastic washer fl'om the right side to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the dora:
t I PlasticWasher
o.J /
#\
For models with a base grille, befl>re replacing the
base grille, remoxe the grille cap b) remoxing the
screw. Screw the cap to the opposite side.
Replace the base grille by inserting the tops of the
metal clips into the ox_fl vents, making sure one of the
plastic tabs on the back of the grille goes into each of
the oven vents. Then push the bottom of the grille
forward tmfil it snaps into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remo_e tile center hinge bracket by removing the
three Torx <_>sci'ews.
NOTE: Kee I) these screws with the hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
On some models, you will need to remove the colo_
matched caps fl'om the screw heads befi)re you can
remoxe the screws. Use the edge of a thin flat blade to
genfl) pi T tile caps off the screw heads. (A put_' knife
works well for this.) Coxer the blade with tape to
prex ent scratching, the I)aim.
Remoxe the three Torx screws f_om the center left
side of the cabinet. Screw them into the holes on
the right side.
Place the center hinoe bracket oxer the holes at
the center left side of the cabinet. Insert and
tighten the three long screws.
Replace the caps b) snapping them oxer the screws
with your finger.
[] TRANSFER DOOR STOPS
On each doo_, mo_e the metal door stop from the
fight to the left.
Moxe any screws from the left to the fight.
DoorSto
\
Left Side Right Side
2O
Loading ...
Loading ...
Loading ...