Loading ...
Loading ...
Loading ...
ASSEMBLY
Two people are required for assembly, Set the treadmill in a cleared area and remove all packing materials.
Do not dispose of the packing materials until assembly is completed. Assembly requires the following tools:
The included 7132" allen wrench _ and your own phillips screwdriver _.
.
Firmly hold one of the Uprights (6, 88) as shown. Raise
the Uprights until the base is resting on the floor.
The inset drawing shows how the treadmill should ap-
pear when this step is completed.
.
Loosen the Crossbar Bolts (1) in the ends of the Console
Crossbar (9). Pivot the Console (10) to the angle shown.
Look under the Left and Right Console Brackets (3, 36)
and find the two small holes in each end of the Console
Crossbar (9). Tighten Crossbar Screws (104) into all four
holes.
Pivot the Console (10) upward until itstops. Using the
7/32" Allen Wrench (89), tighten the Crossbar Bolts (1).
2
1
\
6
3. Remove the paper backing from the Adhesive Clip (26).
Press the Adhesive Clip onto the Frame (49) in the indi-
cated location. Press the 3/16" Allen Wrench (83) into the
Adhesive Clip. The use of the 3/16" Allen Wrench isde-
scribed on page 12.
Make sure that all parts are tightened before you use the
treadmill. Note: Cover the floor beneath the treadmill to
protect the floor or carpet.
49
Loading ...
Loading ...
Loading ...