Loading ...
Loading ...
Loading ...
ENGLISH
WWW.STIEBEL-ELTRON-USA.COM MINI
™
SERIES TANKLESS ELECTRIC WATER HEATERS | 15
INSTALLATION INSTRUCTIONS
7.3 Electrical connection
WARNING: BEFORE BEGINNING ANY WORK ON THE
ELECTRIC INSTALLATION, BE SURE THAT THE MAIN CIRCUIT
BREAKER PANEL SWITCH IS “OFF” TO AVOID ANY DANGER OF
ELECTRIC SHOCK. FAILURE TO DO SO MAY RESULT IN SERIOUS
INJURY OR DEATH. ALL MOUNTING AND PLUMBING MUST BE
COMPLETED BEFORE PROCEEDING WITH ELECTRICAL HOOK-UP.
WHERE REQUIRED BY LOCAL, STATE OR NATIONAL ELECTRICAL
CODES, THE CIRCUIT SHOULD BE EQUIPPED WITH A GROUND FAULT
INTERRUPTER.
WARNING: AS WITH ANY ELECTRIC APPLIANCE, FAILURE TO
ELECTRICALLY GROUND UNIT MAY RESULT IN SERIOUS INJURY OR
DEATH.
CAUTION: INSTALLING A MINI 2-1, MINI 2.5-1, MINI 3-1, OR
MINI 3.5-1 ON A 208 V OR 220–240 V CIRCUIT WILL DESTROY
THE HEATING ELEMENT. THIS IS CONSIDERED IMPROPER
INSTALLATION AND WILL VOID YOUR FACTORY WARRANTY.
Voltage
Mini 2-1: 110–120 V
Mini 2.5-1: 110–120 V
Mini 3-1: 110–120 V
Mini 3.5-1: 110–120 V
Mini 4-2: 220–240, 208 V
Mini 6-2: 220–240, 208 V
1. All electrical work must comply with national and applicable state
and local electrical codes.
2. The Mini should be connected to a properly grounded dedicated
branch circuit of proper voltage rating. In installa tions with several
Mini units, each unit requires an independent circuit. Please refer to
the technical data table for the correct wire and circuit breaker size.
3. The open ends of the “pigtail” must be feed into an electrical
junction box. Then feed wires through strain relief clamp and tighten
clamp down on wire.
4. Reinstall plastic cover.
Loading ...
Loading ...
Loading ...