Loading ...
Loading ...
Loading ...
User manual
16
SERVICE
BEFORE CONTACTING THE TECHNICAL ASSISTANCE SERVICE
• Check whether you can solve the problem alone (see
“Troubleshooting”).
• Restart the wash cycle to check whether the problem has
been solved.
• If this is not the case, contact an authorised Technical
Assistance Centre.
! Always request the assistance of authorised technicians.
CONTACT OUR TECHNICAL ASSISTANCE SERVICE
If after the above checks the fault still occurs, get in touch
with the nearest Technical Assistance Service (See phone
number in the warranty booklet)
Have the following information to hand:
• the type of problem;
• the appliance model (Mod.);
• the serial number (S/N).
This information can be found on the data plate applied to
the rear of the washing machine, and can also be found on
the front of the appliance by opening the door.
XXXXXXXXXX
ELECTRICAL CONNECTION
FOR GREAT BRITAIN ONLY
Warning - this appliance must be earthed.
Fuse replacement
If the mains lead of this appliance is tted with a BS 1363A
13amp fused plug, to change a fuse in this type of plug use an
A.S.T.A. approved fuse to BS 1362 type and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3. Ret both into plug.
Important:
The fuse cover must be retted when changing a fuse and if
the fuse cover is lost the plug must not be used until a correct
replacement is tted. Correct replacement are identied by the
colour insert or the colour embossed in words on the base of
the plug. Replacement fuse covers are available from your local
electrical store.
For the Republic of Ireland only
The information given in respect of Great Britain will frequently
apply, but a third type of plug and socket is also used, the
2-pin, side earth type.
Socket outlet / plug (valid for both countries)
If the tted plug is not suitable for your socket outlet,
Please contact After-Sales service for further instruction.
Please do not attempt to change plug yourself. This procedure
needs to be carried out by a qualied technician in compliance
with the manufactures instructions and current standard safety
regulations.
Loading ...
Loading ...