GE - General Electric AHE12DZW1 OWNER’S MANUAL & INSTALLATION INSTRUCTIONS

Loading ...

4 49-5000622 Rev. 2

USING THE AIR CONDITIONER

Features and appearance will vary.

Lights beside the touch pads on the air conditioner control panel

indicate the selected settings.

Remote Control

Air Conditioner Controls

Auto

Cool

Speed

Mode

Med

High

Fan Eco

Heat

Low

Filter

Reset

Delay

Sleep

Mode

1 2 3 4

8 7

1. Power Pad

Turns air conditioner on and off. When turned on,

the display will show the Set temperature.

2. Display

Shows the room temperature in Fan mode. Shows

the Set temperature while setting the temperature in

Cool, ECO or Heat modes.

7HPSDQG'HOD\,QFUHDVHޔ'HFUHDVHޕ

pads

8VHWRVHWWHPSHUDWXUHRUGHOD\WLPH7HPSHUDWXUH

can be set in Cool, ECO or Heat mode.

4. Mode Pad

8VHWRVHWWKHDLUFRQGLWLRQHUWR Cool, Fan, Eco, or

Heat mode.

5. Fan Speed Pad

In Cool, ECO or Heat PRGH8VHWRVHWWKHIDQ

speed to Auto, High, Med or Low on the unit.

In Fan PRGH8VHWRVHWWKHIDQVSHHGWR High,

Med, or Low on the unit.

6. Delay Pad

Delay ON—When the air conditioner is off, it can be

set to automatically come on in 1 to 24 hours at its

previous mode and fan settings.

Delay OFF—When the air conditioner is on, it can

be set to automatically turn off in 1 to 24 hours.

How to set:

Press the Delay pad. Each touch of the Increase

ޔ'HFUHDVHޕpads will set the timer in

1-hour intervals.

To review the remaining time on the Delay timer,

SUHVVWKH'HOD\8VHWKH,QFUHDVHޔ'HFUHDVH

ޕpads to set a new time if desired.

To cancel the timer, press 'HFUHDVHޕpad until the

set time is --.

7. 6OHHS3DGVHWE\DLUFRQGLWLRQHUFRQWUROVRQO\

The Sleep mode sets the unit to gradually change

settings over an 8 hour period to allow for some

increased energy efficiency during sleep hours.

The Sleep mode is available only in Cool, Heat and

Fan only settings.

Press the Sleep mode pad and its light will

illuminate. The fan indicator will stay at the same

setting but the air conditioner will automatically

change the Fan speed to low in either Cool, Heat or

Fan only mode.

In Fan only mode, the fan will stay in the Low speed

setting for 8 hours. After 8 hours, the air conditioner

will turn off.

In Cool mode, the fan will stay in the Low speed

setting for 8 hours from the time the Sleep mode

pad was pressed. The air conditioner will also

raise the set point 2°F in 30 minutes and 2°F more

in another 30 minutes where it will remain for the

QH[WKRXUV$IWHUKRXUVWKHDLUFRQGLWLRQHUZLOO

turn off.

In Heat mode, the fan will stay in the Low speed

setting for 8 hours from the time the Sleep mode

pad was pressed. The air conditioner will also

lower the set point 2°F in 30 minutes and 2°F more

in another 30 minutes where it will remain for the

QH[WKRXUV$IWHUKRXUVWKHDLUFRQGLWLRQHUZLOO

turn off.

While the unit is in SLEEP mode, pressing any pad

H[FHSWWIFISDGWKHXQLWZLOOH[LWSLEEP mode.

8. Filter Reset Pad

This feature automatically notifies you that the air

filter must be cleaned. The indicator light will come

on after 250 hours of operation. Clean the air filter

(refer to page 6), place it back in the front panel,

and press the Filter Reset pad. The light will go off.

Controls

Power

Speed

Mode

Eco

Delay

Loading ...

GE AHE12DZW1 12,000 BTU Heat/Cool Electronic Window Air Conditioner

OWNER’S MANUAL & INSTALLATION INSTRUCTIONS - Page 4