Loading ...
Loading ...
Loading ...
assemb|y
6. Insert Spreader Rod into Spreader Support until pin
fits into notch. Insert Thumbscrew and tighten it.
THUMB SCREW
\
\
SPREADER
ROD
\
\
FLAT
SURFACE
\ (INTO SUPPORT)
17 "
U
SPREADER
SUPPORT
7. Slide Spreader Rod into Blade Guard Support until
end of Rod is even with edge of Support. Tighten
Hex Head Screw in Support.
8. Attach Spreader to Spreader Support so that the
edge of the Spreader is ever_with the edge of the
Spreader Support. Tighten screws.
9. Raise Anti-Kickback Pawls (hold in place with a set-
screw wrench - see below). AlignSpreader SQUARE
to table,
Tighten both 5/16-18 x 1 inch Hex Head Screws.
1/-2ONE\ I II II _L-""-.-.._
HD. SCREW ___\ I_'__
114 IN. LOCKWASHER _ II I.j'_Trr'" \ /l_";) _J/.i/"
,,,-,O.EX.UT '/I I t
SPREADER EDGE f I II "_.%'_ , _t_J \\ v_l I
EVEN WITH SPREADER I U _h_'_ \/_--II \\ \\ _1 I
EmDOFROD - _ ,J,/_-'<'-"_---_A\ I I
EVEN WiTH EDGE _ _._=1 _ _.._._ I [
10. Raise blade all the way up, make sure it is square
with table.
11. Raise Blade Guard. Lift up both Anti-Kickback
Pawls. Insert one of the Setscrew Wrenches in the
notches to hold the Pawlsout of the way.
13.Loosen Hex Head Screw in Guard Support and
move Spreader so that it touches blade of square.
Tighten screw.
HE\ HD.
SCREW
Loading ...
Loading ...
Loading ...